Design of multifunctional catalytic reactor for methane partial oxidation by combining Mn-hexaaluminate and MgO with uniform and non-uniform mixing methods

Huaming Dai,Hongting Wang,Ziwei Song

DOI: https://doi.org/10.1016/j.apenergy.2024.122724

IF: 11.2

2024-02-04

Applied Energy

Abstract:The combination of multifunctional catalysts was beneficial to methane conversion and hydrogen production. In order to improve the synergistic effect of different functional catalysts, LaMnAl 11 O 19 and MgO catalysts were loaded on Al 2 O 3 pellets to prepare LaMnAl 11 O 19 /Al 2 O 3 (LMA) and MgO/Al 2 O 3 (MA) catalytic pellets. Through the uniform distribution and non-uniform mixing of LMA and MA, the different catalytic reactors were built to study the methane combustion performance. The results indicated that the high-activity center of Mn 4+ in LMA increased methane activation rate and the abundant oxygen vacancies in MA promoted active oxygen migration. When the bed length ratio of LMA to MA was 2:2, the oxygen migration rate and methane activation rate achieved the optimal coupling and reached the highest hydrogen energy conversion efficiency of 55.5%. Meanwhile, the good low-temperature catalytic activity and the shortest stabilization time of 4322 s were obtained when the LMA was located in the inner layer. The increase of LMA and MA volume ratio under non-uniform mixing was beneficial to methane conversion and syngas production, and the volume ratio of 2:2 reached excellent high-temperature catalytic activity. Therefore, the uniform and non-uniform mixing of different functional catalysts improved the synergistic effect of catalysts and effectively adjusted the combustion performance of methane.

energy & fuels,engineering, chemical