On the Use of Foam Rubber for Sealing Applications

T. Alexopoulos,E. N. Gazis,S. Maltezos,G. Koutelieris,B. N. J. Persson

DOI: https://doi.org/10.1007/s11249-024-01845-5

2024-03-12

Tribology Letters

Abstract:O-rings made from foam rubber are often used in sealing applications. Foam rubber have low (macroscopic) elastic modulus resulting in a low nominal contact pressure when squeezed against a countersurface. In most cases the foam rubber is covered by a thin surface film with the effective elastic modulus . We show that the nominal contact pressure may not be high enough for the contact area to percolate and the O-ring seal will leak. For the leakage calculations we use the Persson multiscale contact mechanics theory, and the (modified) Bruggeman effective medium theory for the fluid flow conductivity. The experimental input for the theory are surface roughness power spectrum, which was obtained from stylus topography measurements, and the elastic properties ( and ) of the rubber O-ring. As an application of this calculation method, we have used the preliminary as well as the final results of the laboratory gas tightness tests of the 136 New Small Wheel Micromegas Quadruplets performed at CERN, from February 2019 to May 2021, in the framework of the ATLAS Experiment upgrade. In the integration quality control, a novel method for gas tightness measurement, that we have called "Flow Rate Loss", has been used as a baseline method.

engineering, chemical, mechanical

What problem does this paper attempt to address?

The paper primarily explores the leakage issues of foam rubber O-rings in sealing applications. Specifically, the study focuses on the following aspects:

1. **Contact Mechanics**: The paper utilizes Persson's multiscale contact mechanics theory to analyze the contact situation between the foam rubber O-ring and the contact surface. Due to the low elastic modulus of foam rubber (macroscopic elastic modulus \( E_0 \)), the nominal contact pressure is relatively low, which may not be sufficient to make the contact area reach a connected state when compressed (i.e., contact area ratio \( A/A_0 > 0.42 \)).

2. **Effect of Surface Film**: The paper points out that foam rubber O-rings usually have a thin surface film (about 50 micrometers thick), and the effective elastic modulus of this film \( E_1 \) is greater than \( E_0 \). This film reduces the contact area, increasing the likelihood of sealing leakage.

3. **Leakage Calculation Method**: To calculate the leakage rate, the paper employs an improved Bruggeman effective medium theory to compute fluid flow conductivity, combined with the surface roughness power spectrum for analysis. Experimental inputs include the surface roughness power spectrum and the elastic properties of the rubber O-ring (\( E_0 \) and \( E_1 \)).

4. **Experimental Validation**: The paper also uses the gas tightness test data from the Micromegas quadruplet detectors on the New Small Wheel of the CERN ATLAS experiment for validation. By comparing the calculated results with actual measurement data, the impact of different film thicknesses on the leakage rate is assessed.

In summary, the paper aims to explore the leakage mechanisms and influencing factors of foam rubber O-rings in sealing applications through theoretical analysis and experimental validation.