Novel green lubricated materials: Aqueous PAI-MoS2-graphite bonded solid lubricating coating

Bin Li,Weikang Xv,Peng Liu,Dequn Huang,Xinting Zhou,Ruifang Zhao,Shuangjian Li,Qunfeng Liu,Xiaofang Jiang
DOI: https://doi.org/10.1016/j.porgcoat.2021.106225
IF: 6.6
2021-06-01
Progress in Organic Coatings
Abstract:<p>In this paper, a series of the environmental-friendly aqueous PAI-MoS<sub>2</sub>-graphite bonded solid-lubricating coatings (BSLCs) are prepared depending on the design concept of the recombination of two-component lubricant and aqueous resin, and the mechanical strength and wear resistance of the coatings are deeply optimized by virtue of the synergy of the components of coatings. The experimental results demonstrate that the successful preparation of aqueous BSLCs greatly reduces the utilization of toxic organic solvents and is conducive to environmental protection and resource conservation. Doping an appropriate amount of graphite into the aqueous BSLCs is beneficial to maximize the promotion of the mechanical and tribological properties of the coating, and when the mass ratio of graphite to MoS<sub>2</sub> (MRGM) is 0.3, the mechanical strength, friction reduction and wear resistance of the coatings display the comparable level as that of the organic-solvent based BSLCs. Based on the analysis of the variations of the morphology, structure and chemical composition of the wear scars, the corresponding active mechanisms on the mechanical and tribological properties of the coating are investigated in depth.</p>
materials science, coatings & films,chemistry, applied
What problem does this paper attempt to address?
The paper aims to address the optimization of environmentally friendly water-based solid lubricant coatings (BSLCs) in terms of mechanical strength and wear resistance. Specifically, the study prepared a series of environmentally friendly water-based solid lubricant coatings by compounding polyamide-imide (PAI) resin with different proportions of graphite and molybdenum disulfide (MoS₂). The main objective of the research is to reduce the dependence of traditional organic solvent-based solid lubricant coatings on toxic organic solvents, thereby enhancing the environmental friendliness and resource efficiency of the coatings. By systematically adjusting the basic components and relative contents of the coatings, the study comprehensively explored the structure, mechanical, and frictional wear properties of the coatings. Through the analysis of the morphology, structure, and chemical composition changes of the wear traces, the active mechanisms related to the mechanical and frictional wear properties of the coatings were deeply investigated. Additionally, the study found that incorporating an appropriate amount of graphite at specific ratios can significantly enhance the mechanical strength, friction reduction, and wear resistance of the coatings, making the performance of water-based coatings comparable to that of organic solvent-based coatings. This helps to promote the development of traditional organic solvent-based solid lubricant coatings towards a low-carbon and environmentally friendly direction and applies the design concept of multiple synergistic lubricants to improve the mechanical and frictional wear properties of water-based coatings.