Abstract:Solid-state transformers (SST) are emerging technologies to replace the conventional low-frequency main transformer (MTR) in railway vehicles. In order to isolate the load side from the AC 25 kV high-voltage (HV) side and to reduce the whole size of the SST, HV insulation and high-frequency transformers should be used in DC/DC converters. Furthermore, due to the severe constraint of installation space and difficulty of heat dissipation management in the bottom of railway vehicles, high-power density and minimum transformer loss should be considered. To satisfy such design requirements of the proposed SST for railway vehicles, high efficiency integrated transformers, which inherently have leakage inductance, are proposed for dual-active-bridge (DAB) converters in this paper. In order to obtain appropriate equivalent leakage inductance for the DAB converters, a calculation methodology for the leakage inductance has been introduced and verified by simulation. Two separated winding structures in the center-core are adopted to improve the core loss, and appropriate winding turns with 60 kV HV insulation capability are selected, according to the proposed design procedure of the integrated transformers. In order to compare the proposed transformers with the conventional transformer having additional inductors and to verify the major characteristics of the transformers, two 125 kW proposed transformers and conventional transformers have been built and evaluated by an 250 kW SST module, operating at 10 kHz switching frequency. Under a 125 kW full-load condition, 99.7% transformer efficiency was obtained by the proposed integrated transformers, which are 4.7% smaller and 7.0% lighter than the conventional transformer. As a result, 26°C maximum temperature improvement has been obtained and 60k V HV insulation capability has been satisfied by the proposed integrated transformers.

Design and Optimization of the Insulation of Medium-voltage Medium-frequency Transformers for Solid-state Transformers

Design and Testing of a Medium Frequency Transformer

Modeling and Design of a Medium Frequency Transformer with High Isolation and High Power-Density

A Soft-Switching Solid-State Transformer Module

Design of Medium-Voltage High-Frequency Transformers Based on High-Thermal-Conductivity Insulation Material

A Soft Start Approach of Solid-State Transformer

Design of a High-Voltage-Insulation and High-Efficiency Medium Frequency Transformer

Modeling and Design of Insulation Structure for High Power Density Medium Voltage High-Frequency Transformers

Design and experiment of a zero-voltage-switching module for bidirectional DC solid-state transformer

Optimization of Medium-Frequency Transformers with Large Capacity and High Insulation Requirement

Research on Voltage and Power Balance Control for Cascaded Modular Solid-State Transformer

Design of coaxial transformer for modular isolated DC/DC converters

Development of Multi-Domain Design Tool for Medium Voltage High Frequency Power Transformers

Efficiency Enhancement of DC Solid-State Transformers by Dynamically Adjusting Active Cells

Design and Optimization of High Insulation Voltage Planar Transformer for DC-DC Converters

Design And Demonstration Of A Sic-Based 800-V/10-Kv 1-Mw Solid-State Transformer For Grid-Connected Photovoltaic Systems

An Optimization Design System of Medium Frequency Transformer with Non-Ideal Geometry Structure

Design Methodology for Inductor-Integrated Litz-Wired High-Power Medium-Frequency Transformer With the Nanocrystalline Core Material for Isolated DC-Link Stage of Solid-State Transformer

DC Voltage Ripple Optimization of a Single-Stage Solid-State Transformer Based on the Modular Multilevel Matrix Converter

Design of Saturated Coupling Transformer in a New Bridge-type Solid State Fault Current Limiter

High Efficiency Integrated Transformer Design in DAB Converters for Solid-State Transformers