Abstract:With the ongoing promotion and adoption of electric vehicles, intelligent and connected technologies have been continuously advancing. Electrical control systems implemented in electric vehicles have emerged as a critical research direction. Various drive-by-wire chassis systems, including drive-by-wire driving and braking systems and steer-by-wire systems, are extensively employed in vehicles. Concurrently, unavoidable issues such as conflicting control system objectives and execution system interference emerge, positioning integrated chassis control as an effective solution to these challenges. This paper proposes a model predictive control-based longitudinal dynamics integrated chassis control system for pure electric commercial vehicles equipped with electro–mechanical brake (EMB) systems, centralized drive, and distributed braking. This system integrates acceleration slip regulation (ASR), a braking force distribution system, an anti-lock braking system (ABS), and a direct yaw moment control system (DYC). This paper first analyzes and models the key components of the vehicle. Then, based on model predictive control (MPC), it develops a controller model for integrated stability with double-layer torque distribution. The required driving and braking torque for each wheel are calculated according to the actual and desired motion states of the vehicle and applied to the corresponding actuators. Finally, the effectiveness of this strategy is verified through simulation results from Matlab/Simulink. The simulation shows that the braking deceleration of the braking condition is increased by 32% on average, and the braking distance is reduced by 15%. The driving condition can enter the smooth driving faster, and the time is reduced by 1.5 s~5 s. The lateral stability parameters are also very much improved compared with the uncontrolled vehicles.

Model Predictive Vehicle Yaw Stability Control via Integrated Active Front Wheel Steering and Individual Braking

Vehicle Dynamic Control Model and Electronic System

MPC-based Yaw Stability Control in In-Wheel-motored EV Via Active Front Steering and Motor Torque Distribution

An NMPC-Based Integrated Longitudinal and Lateral Vehicle Stability Control Based on the Double-Layer Torque Distribution

Robust Vehicle Yaw Stability Controlby Active Front Steering with Active Disturbance Rejection Controller

Interacting multiple model-based yaw stability control for distributed drive electric vehicle via adaptive model predictive control algorithm

Enhancing Vehicle Braking Performance on U-Split Road Through Active Steering Intervention

Adaptive Model Predictive Control of Yaw Rate and Lateral Acceleration for an Active Steering Vehicle Based on Tire Stiffness Estimation

Vehicle stability enhancement and rollover prevention by a nonlinear predictive control method

Integrated Vehicle Chassis Control Based on Direct Yaw Moment, Active Steering and Active Stabiliser

Integrated control of braking-yaw-roll stability under steering-braking conditions

Enhancement of Vehicle Stability Based on Coordinated Active Rear Steering and Additional Yaw Moment

Model-Based Vehicle Stability Control with Tyre Force and Instantaneous Cornering Stiffness Estimation

An individualized robust stability control strategy for active front steering vehicles

Improving vehicle dynamics employing individual and coordinated sliding mode control in vehicle stability, active front wheel steering and active rear wheel steering systems in co-simulation environment

New Integrated Vehicle Stability Control of Active Front Steering and Electronic Stability Control Considering Tire Force Reserve Capability

Research on the Potential of Front Wheel Steering Control for Vehicle Dynamics Control

Active rack control of steer-by-wire systems for vehicle lateral stability

Linear Subsystem Model for Real-time Control of Vehicle Stability Control System

Vehicle stability control based on synergistic effect of active steering and differential braking

Integrated Strategy for Vehicle Dynamics Stability Considering the Uncertainties of Side‐slip Angle