Abstract:Nanometer scale power amplifiers (PA) at sub-THz suffer from severe parasitic effects that lead to experience limited maximum frequency and reduced power performance at the device transceiver front end. The integrated circuits researchers proposed different PA design architecture combinations at scaled down technologies to overcome these limitations. Although the designs meet the minimum requirements, the power added efficiency (PAE) of PA is still quite low. In this paper, a W-band single-ended common-source (CS) and cascode integrated 3-stage 2-way PA design is proposed. The design integrated different key design methodologies to mitigate the parasitic; such as combined Class AB and Class A stages for gain-boosting and efficiency enhancement, Wilkinson power combiner for higher output power, linearity, and bandwidth, and transmission line (TL)-based wide band matching network for better inter-stage matching and compact size. The proposed PA design is validated using UMS 150-nm GaAs pHEMT using advanced design system (ADS) simulator. The results show that the proposed PA achieved a gain of 20.1 dB, an output power of 17.2 dBm, a PAE of 33 % and a 21 GHz bandwidth at 90 GHz Sub-THz band. The PA layout consumes only 5.66 X 2.51 mm2 die space including pads. Our proposed PA design will boost the research on sub-THz integrated circuits research and will smooth the wide spread adoption of 6G in near future.

Smith Chart-Based Design of High-Frequency Broadband Power Amplifiers

A High Linearity Class AB Power Amplifier for Sub-1 GHz Applications

A Class-F Based Power Amplifier with Optimized Efficiency in Triple-Band

A 100–117 GHz W-Band CMOS Power Amplifier With On-Chip Adaptive Biasing

Design and Analysis of a 26–34.5-Ghz Power Amplifier with Balanced Mismatch Reduction and Interstage Matching

X-Band High-Efficiency Continuous Class B Power Amplifier Gan Mmic Assisted By Input Second-Harmonic Tuning

Design and Analysis of RF Power Amplifying Circuit Based on Smith Chart

A Broadband Design For High-Efficiency Power Amplifiers

A 2.6ghz Class-AB GaN Power Amplifier with Maximum Output Power of 56W Achieving 70% Power Added Efficiency

Design of GaN Based Multi-Octave Wideband Power Amplification Circuit

Novel Design Space of Broadband High-Efficiency Parallel-Circuit Class-EF Power Amplifiers

Design of Broadband Highly Efficient Power Amplifier Based on Low‐Pass Filtering Network With Periodic Structure

Design of a W-band High-PAE Class A&AB Power Amplifier in 150nm GaAs Technology

A 0.8-5.8 GHz Ultra-wideband Power Amplifier Based on Dynamic Renormalized References

Design of A Compact 2–6 GHz High-Efficiency and High-Gain GaN Power Amplifier

Design of a broadband high-efficiency power amplifier based on ring-resonant filter with compensation architecture and a series of continuous modes

A Broadband Doherty Power Amplifier Design by Optimizing Its Load Modulation Network

Design of Continuous-Mode Gan Power Amplifier with Compact Fundamental Impedance Solutions on Package Plane

A High Power X-band GaN Solid-State Power Amplifier with 55% PAE

A New Method of Designing High Efficiency and Wideband Power Amplifier

Design of 35-dB 0.03-to-2.7 GHz Two-Stage Broadband Power Amplifier With 37.2 dBm P sat Using Modular Technology