Abstract:Here, we focus on induced degradation and spatial inhomogeneity of organic photovoltaic devices under different environmental conditions, uncoupled from the influence of a hole-transport (HT) layer. During testing of devices comprising the standard photoactive layer of P3HT as donor, blended with PCBM as acceptor, a comparison was made between the nonencapsulated devices upon exposure to dry air, dry air with illumination and humid air. The impact on the active layer's photophysics is discussed, along with the device physics in terms of integral solar cell performance and spatially resolved photocurrent distribution with point-to-point analysis of the diode characteristics to determine the origin of the observed behavior. The results show that even without the widely used hygroscopic HT layer, PEDOT:PSS, humidity is still a major factor in the short-term environmental degradation of organic solar cells with this architecture, and not only oxygen or light, as is often reported. Different from previous reports where water-induced device degradation was spatially homogeneous and formation of Al2O3 islands was only seen for oxygen permeation through pinholes in aluminum, we observed insulating islands merely after humidity exposure in the present study. Further, we demonstrated with laser beam induced current mapping and point-to-point diode analysis that the water-induced performance losses are a result of the exposed device area comprising regions with entirely unaltered high output and intact diode behavior and those with severe degradation showing detrimentally lowered output and voltage-independent charge blocking, which is essentially insulating behavior. It is suggested that this is caused by transport of water through pinholes to the organic/metal interface, where they form insulating oxide or hydroxide islands, while the organic active layer stays unharmed.

Insight into Air Degradation of Inverted Perovskite Solar Cells with Different Cathode Interlayers

Comprehensive Understanding of Heat-Induced Degradation of Triple-Cation Mixed Halide Perovskite for a Robust Solar Cell

Direct Evidence of Ion Diffusion for the Silver‐Electrode‐Induced Thermal Degradation of Inverted Perovskite Solar Cells

Degradation Kinetics of Inverted Perovskite Solar Cells

Effect of Ion Migration-Induced Electrode Degradation on the Operational Stability of Perovskite Solar Cells

Interfacial Degradation of Planar Lead Halide Perovskite Solar Cells

Effect of Ion Migration Induced Electrode Degradation on the Operational Stability of Perovskite Solar Cells

Gaining Insight Into The Effect Of Organic Interface Layer On Suppressing Ion Migration Induced Interfacial Degradation In Perovskite Solar Cells

Interfacial stabilization for inverted perovskite solar cells with long-term stability

Impact of hole-transport layer materials on the field-induced degradation of p-i-n perovskite solar cells

A Chemically Inert Bismuth Interlayer Enhances Long-Term Stability of Inverted Perovskite Solar Cells.

Reversible degradation in hole transport layer‐free carbon‐based perovskite solar cells

Using Ultra-High Molecular Weight Hydrophilic Polymer As Cathode Interlayer for Inverted Polymer Solar Cells: Enhanced Efficiency and Excellent Air-Stability

Enhanced efficiency and stability of perovskite solar cells with ultra-thin Al2O3 contact interlayer via low temperature atomic layer deposition

Unveiling and Overcoming Instabilities in Perovskite Solar Cells Induced by Atomic‐Layer‐Deposition Tin Oxide

Improving Thermal Stability of Perovskite Solar Cells by Suppressing Ion Migration

Electric‐Induced Degradation of Cathode Interface Layer in PM7:IT‐4F Polymer Solar Cells

Short-Term Environmental Effects and Their Influence on Spatial Homogeneity of Organic Solar Cell Functionality

Improvement in the Performance of Inverted 3D/2D Perovskite Solar Cells by Ambient Exposure

Corrosive Behavior of Silver Electrode in Inverted Perovskite Solar Cells Based on Cu:NiO X

Suppressed Decomposition of Organometal Halide Perovskites by Impermeable Electron-Extraction Layers in Inverted Solar Cells