SCAPS 1D based study of hole and electron transfer layers to improve MoS2−ZrS2 solar cell efficiency
BHOOMI S SHAH,Jiten P Tailor,Sunil H. Chaki,Milind P Deshpande
DOI: https://doi.org/10.1088/1361-651x/ad5a2b
IF: 2.421
2024-06-21
Modelling and Simulation in Materials Science and Engineering
Abstract:In the realm of photovoltaic applications, scientists and technocrats are striving to maximize the solar cell input photon energy conversion to electricity. However, achieving optimal cell efficiency requires significant time and energy investment for each variation and optimization. To overcome this issue authors studied and simulated the fabricated cell for optimizing conditions, which can save time and efforts for the relatively better outcomes. The family of transition metal chalcogenides holds promise as a material that yield improved outcomes in optoelectronic applications, particularly in photovoltaics. These materials are employed in trials aimed at enhancing solar cell parameters, resulting in the development of the FTO/ZnO/ZrS2/MoS2/CuO/Au composite cell. Numerical simulations utilizing SCAPS-1D software is conducted, focusing on the significance of CuO as a hole transport layer (HTL), and ZnO as an electron transport layer (ETL). The investigation delves into the impact of various factors, including thickness, bandgap, and carrier densities for both HTL and ETL, on fundamental solar cell parameters. The study reveals that device parameters are influenced by factors such as recombination rate, photogenerated current, charge carrier length, and built-in-voltage. Optimized parameters for HTL, including thickness, bandgap, and carrier concentration, are determined to be 035 μm, 12 eV, and 10 1020 cm3, respectively. For ETL, the optimized parameters are found to be 005 μm, 31 eV, and 10 1018 cm3, respectively. With these optimized parameters, the efficiency of the solar cell reached 2064%, accompanied by open circuit voltage, short circuit current density, and Fill Factor values of 0.836 V, 36.021 mAcm2, and 6854%, respectively. The simulated results indicate that addition of two extra layers and the use of efficient binary materials in heterojunction formation can effectively enhance device parameters, offering advantages such as low-cost and large-scale fabrication.
materials science, multidisciplinary,physics, applied