Abstract:Acoustical methods are playing an important role for nondestructive evaluation (NDE) of adhesive-bonded composites and components in industrial applications. A dual-frequency ultrasonic technique is proposed for the quantitative evaluation of contact strength between pressed solid surfaces. An ultrasonic excitation consists of two primary frequency components is applied perpendicular to the interface, and the transmitted wave is examined. Theoretical study is based on a perturbation analysis of contact acoustic nonlinearity (CAN) model, predicting the generation of difference and sum frequency waves, together with the second harmonics. Nonlinear parameters are defined to describe the nonlinearity generation efficiencies. Experiments are performed for three types of interfaces, i. e. the interfaces of two aluminum alloy blocks with and without couplant and two glass blocks. The difference frequency wave component has bigger generation efficiency than other nonlinear components, which offers an advantage of high SNR and good detection capability of contact stiffness (interfacial stiffness). For each interface, the first and second-order interfacial stiffness are measured with contact pressure increasing from near zero to about 0.8 MPa with the aid of a laser interferometer. Finally, numerical simulations are also carried out, and a consistency is found between measurements and calculations. The dual-frequency ultrasound sent to the interface generates at least four second-order nonlinear components, which enriches the CAN technique for interface quality examinations. Both measured and simulated results indicate an increase of interfacial stiffness and decrease of nonlinear parameters with growing contact pressure. Moreover, measured results show that couplant between interfaces influences the contact stiffness evaluations in an enhanced manner, while the contact pressure determined by measured interfacial stiffness values are underestimated due to the couplant. The main problem comes from the contact between the transducersample interfaces, which brings extra nonlinearity to the detected signals and affect the accuracy of measuring. Copyright© (2010) by the International Congress on Acoustics.

Ultrasonic wave simulation in shrink-fit assembly for the estimation of stress at the contact interference

Acoustoelastic determination of local surface stresses in polymethylmethacrylate

Non-destructive evaluation of non-uniform stress fields and subsurface stress gradients using ultrasonic waves

Ultrasonic Measurement of Stress Considering Strain Effect

Acoustoelastic Guided and Surface Waves in Waveguides with Focus on Non-Destructive Testing and Structural Health Monitoring Applications —A Review of Recent Studies

Ultrasonic Measurement of Axial Stress Using High-Frequency Cylindrical Guided Wave

A study on the effect of plasticity on the measurement of residual stresses using ultrasound technique

The Influence of Background Ultrasonic Field on the Strength of Adhesive Zones under Dynamic Impact Loads

Ultrasonic measurement of contact stress at metal-to-metal interface based on a real rough profile through modeling and experiment

Research on ultrasonic assisted press-fit assembly of small interference fits

Evaluation of contact stiffness between solid-solid interfaces using dual-frequency ultrasound

Design and experimental verification of phase-reversal Fresnel lens for contact stress characterization

Stress Measurement of a Pressurized Vessel Using Ultrasonic Subsurface Longitudinal Wave With 1-3 Composite Transducers

Direct, Model-Free Acoustic Evaluation of Stresses and Strains in Loaded Nonlinear Soft Solids

Quantitative Evaluation of Contact Stiffness Between Pressed Solid Surfaces Using Dual-Frequency Ultrasound

A new FEM-based approach on the modeling of stress-induced velocity shift of piezoelectric surface acoustic wave resonators

Application of Ultrasonic Stress Measurement in the Evaluation of Bolt Fastening Force

Theoretical and experimental study on interface stiffness measurement of rough surface using improved acoustic model

Ultrasonic stress detection and regulation in the whole machining process of thin-walled part

Finite-Element Simulation Of Contact-Impact Dynamics For High-Power Ultrasonic Processing System

Uniaxial stress in-situ measurement using EMAT shear and longitudinal waves: Transducer design and experiments