Abstract:Data acquisition systems that receive analog signals, convert them to digital, and perform signal processing are used in a variety of systems that use acoustics, radar, sonar, indoor localization, and navigation. The previous systems, such as NI USRP-RIO, are expensive to build, and the number of signals a single device can receive is limited to between two and four. In order to receive more channels of signals, multi-channel data acquisition systems using ADCs operating at tens of MSPS have been proposed. However, these systems require additional processing time because data acquisition and signal processing are performed on different devices. In this paper, we propose a multi-channel data acquisition system using a 16-channel ADC that can support up to 100 MSPS. In particular, to reduce unnecessary signal transmission time, we propose a one-chip structure where all processes are performed on a single chip. Also, we propose a data acquisition system that applies pipelining techniques to enable real-time processing. To verify the proposed system, we used TI ADS52J90 and a Kintex UltraScale KCU105 evaluation board, and confirmed that it is possible to receive and process all channels simultaneously. Furthermore, it is possible to configure a real-time system by adjusting the speed of the signal-processing operation and the speed of the communication interface. Therefore, the proposed system is expected to reduce the cost of system construction by performing signal reception and processing with a single chip, and to reduce the time required for overall signal processing.

An FPGA-Based ADC Using Multichain Merged Method

A Fully Dynamic 4-Channel 13b Simultaneous Sampling Incremental ΔΣ ADC Using Cascoded Floating-Inverter-Amplifier and Code Division Multiplexing Technique

A 14-bit 500MS/s and 1GS/s Configurable Pipelined ADC with Background Calibration

A Multi-chain Measurements Averaging TDC Implemented in a 40 nm FPGA

A High Resolution Time-to-digital-convertor Based on a Carry-Chain and DSP48E1 Adders in a 28-Nm Field-Programmable-gate-array

The design of a time-interleaved analog-digital conversion modulator based on FPGA-TDC for PET application

Application of FPGA Acceleration in ADC Performance Calibration

A Highly Linear FPGA-Based TDC and a Low-Power Multichannel Readout ASIC with a Shared SAR ADC for SiPM Detectors

FPGA-Based Multi-Channel Real-Time Data Acquisition System

A High-Resolution Tdc Implemented In A 90nm Process Fpga

A 1.7 Ps Equivalent Bin Size and 4.2 Ps RMS FPGA TDC Based on Multichain Measurements Averaging Method

High-Resolution, Multi-Channel FPGA-Based Time-to-Digital Converter

Design of Multi-channel Real-time Signal Acquisition System

Low-cost FPGA-based multi-channel TDC with high resolution and density for time-of-flight detectors

A Design of High Resolution One-Clock-Cycle TDC Based on FPGA

A 19.6 ps, FPGA-Based TDC With Multiple Channels for Open Source Applications

A High-Resolution TDC Design Based on Multistep Fine Time Measurement by Utilizing Delay-Adjustable Looped Carry Chains on FPGAs

High-Speed and Time-Interleaved ADCs Using Additive-Neural-Network-Based Calibration for Nonlinear Amplitude and Phase Distortion

TwinPop: A Resource-Efficient and Highly Linear FPGA-Based Time-to-Digital Converter

FPGA Vernier Digital-to-Time Converter With 1.58 ps Resolution and 59.3 Minutes Operation Range

A 20ps resolution wave union FPGA TDC with on-chip real time correction