Abstract:The high concentration of chloride ions in desulphurization wastewater is the primary limiting factor for its reusability. Monovalent anion selective electrodialysis (S-ED) enables the selective removal of chloride ions, thereby facilitating the reuse of desulfurization wastewater. In this study, different concentrations of NaCl and Na2SO4 were used to simulate different softened desulfurization wastewater. The effects of current density and NaCl and Na2SO4 concentration on ion flux, permselectivity (PSO42−Cl−) and specific energy consumption were studied. The results show that Selemion ASA membrane exhibits excellent permselectivity for Cl− and SO42−, with a significantly lower flux observed for SO42− compared to Cl−. Current density exerts a significant influence on ion flux; as the current density increases, the flux of SO42− also increases but at a lower rate than that of Cl−, resulting in an increase in permselectivity. When the current density reaches 25 mA/cm2, the permselectivity reaches a maximum of 50.4. The increase in NaCl concentration leads to a decrease in the SO42− flux; however, the permselectivity is reduced due to the elevated Cl−/SO42− ratio. The SO42− flux increases with the increase in Na2SO4 concentration, while the permselectivity increases with the decrease in Cl−/SO42− ratio.
engineering, chemical,materials science, multidisciplinary,polymer science,chemistry, physical
What problem does this paper attempt to address?
The problem this paper attempts to address is the separation of chloride ions (Cl⁻) and sulfate ions (SO₄²⁻) from desulfurization wastewater to improve its reusability. Specifically, the high concentration of chloride ions is the main factor limiting the reuse of desulfurization wastewater. By using monovalent anion selective electrodialysis (S-ED) technology, selective removal of chloride ions can be achieved, thereby promoting the reuse of desulfurization wastewater.
### Background of the Paper
1. **Source and Composition of Desulfurization Wastewater**:
- Limestone-gypsum wet flue gas desulfurization technology is widely used in thermal power plants.
- During the desulfurization process, in addition to SO₂, the desulfurization slurry also absorbs a certain amount of Cl⁻, F⁻, and heavy metal ions.
- With the circulation of the desulfurization solution, these ions continuously accumulate and concentrate in the lime slurry.
- Excessive chloride ion concentration can lead to a decline in the quality of desulfurization gypsum, reduce desulfurization efficiency, and potentially cause corrosion of pipelines and equipment.
2. **Limitations of Existing Treatment Technologies**:
- Technologies such as chemical precipitation, evaporation crystallization, spray evaporation, membrane separation, and biological treatment are used for desulfurization wastewater treatment.
- These technologies have their advantages and disadvantages but generally face issues such as high cost, complex operation, or limited treatment effectiveness.
3. **Advantages of Electrodialysis Technology**:
- Electrodialysis (ED), as an efficient membrane separation technology, has been successfully applied in various fields.
- The development of monovalent selective ion exchange membranes (IEMs) provides new options for the selective separation of different ions.
- Monovalent selective IEMs have high selectivity for ions of different valences and sizes, aiding in the separation and purification of various salts in brine.
### Purpose of the Paper
- **Study the Application of Monovalent Anion Selective Electrodialysis (S-ED) in Desulfurization Wastewater Treatment**:
- By simulating different concentrations of NaCl and Na₂SO₄ solutions, study the effects of current density and ion concentration on ion flux, selective permeability, and energy consumption.
- Evaluate the separation performance and energy efficiency of S-ED in treating desulfurization wastewater.
### Experimental Methods
- **Materials and Chemicals**:
- Use deionized water and chemical reagents (such as NaCl and Na₂SO₄) to prepare artificial brine.
- Use Selemion ion exchange membranes for experiments.
- **Experimental Setup and Procedures**:
- Assemble the S-ED stack, using a DC power supply to provide separation force.
- Determine the concentrations of Cl⁻ and SO₄²⁻ by ion chromatography.
- Study the separation performance and energy consumption under different current densities and ion concentrations.
### Results and Discussion
- **Study of Limiting Current Density (LCD)**:
- Different concentrations of NaCl and Na₂SO₄ significantly affect the LCD.
- High concentrations of Cl⁻ and SO₄²⁻ cause changes in LCD, requiring appropriate control of current density in subsequent experiments.
- **Effect of Current Density**:
- Higher current density can accelerate the desalination rate but increases energy consumption.
- Current density significantly affects the flux and selective permeability of Cl⁻ and SO₄²⁻.
- Appropriate current density can achieve high selective permeability and low energy consumption.
- **Changes in Ion Flux and Selective Permeability**:
- The flux of Cl⁻ increases linearly with the increase in current density.
- The flux of SO₄²⁻ is significantly lower than that of Cl⁻, mainly due to Donnan exclusion, dielectric effects, and steric effects.
- Increasing current density increases the flux of SO₄²⁻, but its growth rate is slower.
- **Energy Consumption Analysis**:
- Current density has a significant impact on the energy consumption per unit of NaCl.
- Appropriate current density can achieve low energy consumption.
Through these studies, the paper demonstrates the effectiveness and feasibility of monovalent anion selective electrodialysis (S-ED) in treating desulfurization wastewater, providing a new technical means to improve the reusability of desulfurization wastewater.