Abstract:A discrete element method (DEM) model is developed to simulate the dynamics of wet, flexible fibers. The angles of repose of dry and wet fibers are simulated, and the simulation results are in good agreement with experimental results, validating the wet, flexible fiber model. To study wet fiber flow behavior, the model is used to simulate shear flows of wet fibers in a periodic domain under Lees-Edwards boundary conditions. Significant agglomeration is observed in dilute shear flows of wet fibers. The size of the largest agglomerate in the flow is found to depend on a Bond number, which is proportional to liquid surface tension and inversely proportional to the square of the shear strain rate. This Bond number reflects the relative importance of the liquid-bridge force to the particle's inertial force, with a larger Bond number leading to a larger agglomerate. As the fiber aspect ratio (AR) increases, the size of the largest agglomerate increases, while the coordination number in the largest agglomerate initially decreases and then increases when the AR is greater than four. A larger agglomerate with a larger coordination number is more likely to form for more flexible fibers with a smaller bond elastic modulus due to better connectivity between the more flexible fibers. Liquid viscous force resists pulling of liquid bridges and separation of contacting fibers, and therefore it facilitates larger agglomerate formation. The effect of liquid viscous force is more significant at larger shear strain rates. The solid-phase shear stress is increased due to the presence of liquid bridges in moderately dense flows. As the solid volume fraction increases, the effect of fiber-fiber friction coefficient increases sharply. When the solid volume fraction approaches the maximum packing density, the fiber-fiber friction coefficient can be a more dominant factor than the liquid bridge force in determining the solid-phase shear stress.

The pagoda instability (PI) on soluble fibers

Hydrodynamic Instability of Fiber Suspensions in Channel Flows

On the Non-Linear Instability of Fiber Suspensions in a Poiseuille Flow

STABILITY IN THE CIRCULAR PIPE FLOW OF FIBER SUSPENSIONS

THE EFFECTS OF CLOSURE MODEL OF FIBER ORIENTATION TENSOR ON THE INSTABILITY OF FIBER SUSPENSIONS IN THE TAYLOR–COUETTE FLOW

Stability in Channel Flow with Fiber Suspensions

Bioinspired Anti‐Plateau–Rayleigh‐Instability on Dual Parallel Fibers

On Instability of Dilute Fiber Suspensions in an Axisymmetric Taylor-Couette Flow

Discrete element simulation studies of angles of repose and shear flow of wet, flexible fibers.

Bioinspired Plateau–Rayleigh Instability on Fibers: From Droplets Manipulation to Continuous Liquid Films

Experimental Research on the Hydrodynamic Instability of Fiber Suspensions in Channel Flow

Non-axisymmetric Instability in the Taylor-Couette Flow of Fiber Suspension

Exploration of In-Fiber Nanostructures from Capillary Instability

Fiber Orientation Distributions in Slit Channel Flows with Abrupt Expansion for Fiber Suspensions

Filament formation via the instability of a stretching viscous sheet: Physical mechanism, linear theory, and fiber applications

Hydrodynamic Instability of Semi-concentration Fiber Suspensions Between Two Rotating Coaxial Cylinders

Long-distance Liquid Transport Along Fibers Arising From Plateau-Rayleigh Instability

Investigation of the interactions between two contact fibers in the fiber suspensions

Pinning Effect on the Phase Separation Dynamics of Thin Polymer-Dispersed Liquid Crystals.

Effect of fiber orientation on spinning dynamics for liquid crystalline polymer solutions using mesoscopic theory

Morphology of Fibers Formed Via Thermally Induced Phase Separation of Polypropylene and Liquid Paraffin Blend in Stress-Field