Abstract:Laser diodes have been proposed as a good replacement for light-emitting diodes in high-luminance white light sources. However, laser diodes typically generate very sharp temperature gradients inside the colour-converting elements (CCE) used to produce white light. This poses a thermal management problem in transmissive configurations, where most of the thermal dissipation occurs at the edges of the CCE. The hot spot in the center of the CCE typically drives the efficiency of the system down due to thermal quenching. In this work, we propose a strategy to tackle this issue that is based purely on optical manipulation. By using a free-form lens, the radiation pattern of the laser diode exciting the CCE is tailored so that its power distribution is skewed towards the periphery of the CCE: the zone with the highest thermal dissipation. With this technique, the maximum temperature inside the CCE can be significantly lower than when uniformly illuminating the CCE. Additionally, by lowering the temperature inside the CCE, this technique excites the CCE with a higher radiant flux, allowing higher luminance to be extracted from the system. These results were obtained with a realistic opto-thermal simulation framework and were then experimentally verified.

Improvement of beam quality of high-power edge-emitting lasers using inhomogeneous waveguides

Method to Improve Beam Quality by Compensating Spherical Aberrations in Master Oscillator Power Amplifier Laser Systems

Beam Wavefront Dynamical Compensation by Aberrations of the Gain Medium in Laser Amplifiers for Beam Quality Improvement.

Optical and RIN Spectrum Improvements in Necked Waveguide High-Power DFB Laser Diode

High-performance PCW-DFB laser diodes using offset quantum well epitaxial structures

Beam quality improvement by thermally induced aberrations in a diode-end-pumped laser amplifier

Improvement on stability of direct modulation laser with integrated active feedback by partial corrugated gratings

Fundamental spatial mode high power 808nm double trench wide ridge waveguide laser

Improvement of the Beam Quality of the High Power Solid State Laser Using Phase Conjugation

Beam Profile Evolution and Beam Quality Changes Inside a Diode-End-Pumped Laser Oscillator

Investigation of the gain match in high brightness 980 nm tapered diode laser

Beam Shaping of Edge-Emitting Diode Lasers Using a Single Double-Axial Hyperboloidal Micro-Lens.

Anamorphic beam shaping for efficient laser homogenization: methods and high power applications

Improving the opto-thermal performance of transmissive laser-based white light sources through beam shaping

Beam quality evolution of a quasi-continuous-wave-pumped, passively Q-switched monolithic YAG/Nd:YAG/Cr^4+:YAG microchip

Beam quality improvement by gain guiding effect in end-pumped Nd:YVO 4 laser amplifiers

Extreme Double/Triple Asymmetric Epitaxial Structure Based Diode Lasers for High Powers and High Efficiencies

Progress of Edge-Emitting Diode Lasers Based on Coupled-Waveguide Concept

Beam Quality Improvement of Broad Area Laser Diode with External Cavity Feedback

Thermal Birefringence-Based beam shaping in high energy lasers

Improving optical and electrical properties of InGaN-based green laser diodes by graded-compositional waveguide structure