Abstract:The soil–structure interaction (SSI) effect is nonnegligible during the nonlinear seismic response analysis of large-scale or underground structures. However, the computation of nonlinear response of a structure considering SSI effect usually is a time-consuming process because the numerical model should involve the structure itself, a wide-range soil domain and the soil–structure interface, especially for large-scale structure. This study aims to incorporate the inelasticity-separated finite element method (IS-FEM), which is an algorithm recently developed for efficient structural nonlinear analysis, to improve the efficiency of the soil-structure interaction system. To this end, an inelasticity-separated contact element model for modeling the nonlinear behavior of soil and structure interface is developed in this study. To derive the inelasticity-separated governing equation of this model, a reference elastic stiffness is defined so that the normal and shear deformation of any point pair in the presented contact element is decomposed into reference linear and reference nonlinear parts according to this reference elastic stiffness. As a result, the problem of inconsistency between the requirement of IS-FEM for constant initial linear elastic stiffness and the existence of inflection point for the stress versus relative displacement relationship of contact behavior can be solved. Then, the Goodman element formulation for depicting the nonlinear contact behavior is introduced and an interpolation scheme to establish the reference nonlinear deformation field in an element is incorporated. By combining the proposed model with existing inelasticity-separated elements, a global analytical model of the soil–structure interaction system can be established within the framework of IS-FEM. Because the nonlinearity usually occur in some local regions of the global model and the use of the IS-FEM only require performing these operations for a small scale matrix representing local nonlinearity, the computational efficiency of nonlinear structural response analysis considering SSI effect can be improved significantly. The applicability and efficiency of the proposed method is finally verified by two numerical examples.

Coupled Nonlinear Finite-Element Analysis of Soil–Steel Pipe Structure Interaction

Modelling lateral pipe-soil interaction on soft clay using large displacement sequential limit analysis

Assessment Model of Pipe–soil Interaction During Large-Amplitude Lateral Displacements for Deep-Water Pipelines

Modeling Cyclic Embedment of Deep-Water Pipelines Using Large Displacement Limit Analysis

Dynamic Analyses of Pipes in Saturated Soil under Traffic Loads

Analysis of Effect of Ground Deformation on Buried Pipe

Elastoplastic Pipe-Soil Interaction Analyses of Partially-Supported Jointed Water Mains

FINITE ELEMENT ANALYSIS OF INFLUENCE OF PIPE-JACKING CONSTRUCTION ON ENVIRONMENTS

2-D element analysis of environmental effect caused by pipe jacking

Finite Element Analysis of Compacting Displacements of Single Jacked Pile

Pipeline Lateral Buckling Triggered by the Residual Curvature with Tri-Linear Axial Pipe-Soil Interaction

Seismic Evaluation of Soil–foundation–superstructure System Considering Geometry and Material Nonlinearities of Both Soils and Structures

ANALYSIS OF STABILITY FAILURE FOR PIPELINE DURING LONG DISTANCE PIPE JACKING

Analysis of Superimposed Load Induced by Propulsion of Adjacent Level Parallel Pipe-Jacking

Simulation of soil-structure interaction using inelasticity-separated finite element method

3D Finite Element Analysis of a Super Structure-Foundation-Soil Interaction on the Lateral Loading

Nonlinear Dynamic Analysis Of Saturated Soil-Structure Interaction By Fem

Soil–structure interaction for deeply buried corrugated steel pipes Part I: Embankment installation

Fine Numerical Modeling of Nonlinear Soil-pile-frame Structure Interaction System and Its Verification

Nonlinear FEM Analysis of Steel Beam-to-Concrete Filled Steel Square Tube Column Connections with External Stiffening Rings

Finite Element Modeling Aspects of Buried Large Diameter Steel Pipe–Butterfly Valve Interaction