Abstract:Organic electronics have attracted intensive research interest in the past decades (Chen et al., 2020; Yao et al., 2020; Tang et al., 2021). The ever-increasing demand for organic electronics calls for the development of high-performance and high-stability organic thin-film transistors (OFETs). OFETs are considered key components to fabricate flexible and printable devices for promising applications, such as flexible displays, chemical sensors, wearable devices, and radio frequency identification (RFID) tags. The design and synthesis of novel structural materials (such as semiconductors, dielectrics, electrodes, and substrates), as well as the development of efficient interface engineering strategies, would further promote the development of flexible electronics and lay the foundation for their early commercialization (Ji et al., 2019; Ji et al., 2021). Despite remarkable progress in the development of new materials and relevant applications in organic electronics, some challenges remain, not only on the design and synthesis of novel structural materials (such as π-conjugated small molecule or polymer semiconductors, dielectrics, electrodes, and substrates), but also the development of efficient interface engineering strategies, for the fabrication of high-performance and high-stability devices, and eventually the realization of commercially available products. For example: 1) The need for new π-conjugated semiconductors (small molecule or polymer semiconductors) compatible with polymer dielectric for high-performance devices; 2) The need for polymer dielectric (chemical structures, polarity effects, etc) compatible with commonly used microfabrication technologies for highly integrated miniaturized devices (such as inverter, oscillator, etc); 3) The need for low-voltage and high-currentdensity high-performance devices (new transistor design or high dielectric constant insulators); 4) The strategies for large-scale device fabrication with uniform performance (new fabrication methods); 5) The need for high-stability devices (atmospheric, thermal). This Research Topic aims to address the above-mentioned challenges, including one Editorial, one Review and five Original research. The following themes will provide some clues to promote progress in this area. First of all, a novel photoactive semiconductor (named as IDTOT-4F) with an A-π-D-π-A-type configuration is synthesized for optoelectrical device with photo response and optical memory behaviors provided by W. Huang et al. Then, the development of new efficient interface engineering strategies (electrode approach by W. Li et al.; interface modification by T. Li et al.) for high-performance organic thin-film transistors. In addition, new methods for the construction of high-performance and high-stability organic thin-film transistors and relevant optoelectronic applications, which could be listed in the review article by L. Huang et al. and original research in the paper of W. Wang et al. Finally, X. Ren and co-workers reported a low-temperature solution process to fabricate a high-k metal oxide dielectric for low-power OFET applications. Edited and reviewed by: Liming Dai, Case Western Reserve University, United States

Thermal Stability of the Avalanche-Like Breakdown Performance in Conjugated Polymer-Based Lateral Power Devices

A 2.2kV Organic Semiconductor- Based Lateral Power Device

Off-state Avalanche Breakdown Induced Degradation in 20 V NLDMOS Devices

Experimental Investigation and Analysis of the LDMOS FET Breakdown Under HPM Pulses

Editorial: High-Performance Organic Thin-Film Transistors

Revealing Two-Dimensional Electric Field Crowding Effect in Breakdown Performance of DPPT-TT Polymer-Based OFETs

Influence Of The Dielectric And Of The Active Layer Doping On The Fet Mobility In Ppv-Based Devices

Polymer Electrolyte Dielectrics Enable Efficient Exciton-Polaron Quenching in Organic Semiconductors for Photostable Organic Transistors

Development of Organic Semiconducting Technology to Realize Low Driving Voltages

Crucial role of interfacial thermal dissipation in the operational stability of organic field-effect transistors

Research and Progress on Organic Semiconductor Power Devices

Hysteresis-Free, High-Performance Polymer-Dielectric Organic Field-Effect Transistors Enabled by Supercritical Fluid.

Air- and Active Hydrogen-Induced Electron Trapping and Operational Instability in n-Type Polymer Field-Effect Transistors

From Complexity to Simplicity: Overcoming Photolithography Challenges in Polymer Organic Semiconductor Transistors with Nano-Aluminum Micro-Pattern Infusion Technology

Low-voltage organic field-effect transistors by using solution-processable high-κ inorganic-polymer hybrid dielectrics

Oxygen‐Induced Lattice Strain for High‐Performance Organic Transistors with Enhanced Stability

Potential of the Amorphous Oxide Semiconductors for Heterogeneous Power Integration Applications

Balancing the film strain of organic semiconductors for ultrastable organic transistors with a five-year lifetime

Surface Etching of Polymeric Semiconductor Films Improves Environmental Stability of Transistors

Pursuing Polymer Dielectric Interfacial Effect in Organic Transistors for Photosensing Performance Optimization.

The Quest for Air Stability in Organic Semiconductors