Abstract:Existing vibration displacement control strategies in active magnetic bearing (AMB) flexible rotor systems suffer from a trade-off between damping and noise, which makes it difficult for the system to pass the critical speeds of bending modes. To solve this problem, a rotor vibration velocity and acceleration feedback control strategy based on a non-contact velocity sensor technique is proposed in this paper. The non-contact rotor vibration velocity sensor uses the induced electromotive force caused by changes in the air gap reluctance to measure the rotor vibration velocity. First, an analytical model of the sensor was developed and validated by the finite element method. Then, the structure of the vibration velocity and acceleration feedback control was proposed. Analytical and numerical calculations demonstrated that the rotor vibration velocity feedback is more effective for low-frequency vibrations, whereas the acceleration feedback is utilized to deal with resonances of higher-order bending modes and the weak controllability of the rotor system. To avoid excessive control gains at high frequencies, the least mean square algorithm was adopted to extract the synchronous components of the acceleration. Finally, the experiments were carried out in the AMBs flexible rotor test setup. The results showed that the vibration velocity sensor can be used to assist the proportional–integral–derivative controller to obtain extra damping without significantly increasing the current noise. Low-frequency vibrations were significantly reduced by damping from the rotor vibration velocity feedback. The vibrations at the critical speed of the 2nd bending mode were substantially suppressed by the rotor vibration acceleration feedback.

Real-time application of a dynamic disturbance suppression control approach for an axial active magnetic bearing system

Output Feedback Dynamical Compensation Via EigenStructure Assignment for Active Magnetic Bearings-Rigid Rotor Systems.

Implicit Generalized Predictive Control of an Active Magnetic Bearing System

A Multifrequency Disturbances Identification and Suppression Method for the Self-Sensing AMB Rotor System

Two-Degree-of-Freedom Control for Active Magnetic Bearing Flywheel Rotor System Based on Inverse System Decoupling

Synchronous Disturbance Suppression of Active Magnetic Bearing Rotor Systems Using Variable Period Adaptive Control Algorithm

Novel Decoupling Control and Eigenstructure Assignment Strategies for Rigid Active Magnetic Bearing Rotor System

Non-contact Rotor Vibration Velocity Sensor and Its Application to Vibration Control of a Flexible Rotor on Active Magnetic Bearings

Multi-Objective Optimal Design of Μ–controller for Active Magnetic Bearing in High-Speed Motor

The Effect of Controllers on the Dynamic Behaviour of a Rotor Supported on Active Magnetic Bearings

All-coefficient Adaptive Control of Active Magnetic Bearing System Based on Characteristic Model

Vibration Control for Active Magnetic Bearing High-Speed Flywheel Rotor System with Modal Separation and Velocity Estimation Strategy

Robust Proportional-Differential Control Via Eigenstructure Assignment for Active Magnetic Bearings-Rigid Rotor Systems

Active Control of Active Magnetic Bearings for Maglev Flywheel Rotor System Based on Sliding Mode Control

Vibration Control of Base-Excited Rotors Supported by Active Magnetic Bearing Using a Model-Based Compensation Method

Automatic Measurement of Stiffness and Damping of Active Magnetic Bearings

Study on Inverter-fed Three-pole Active Magnetic Bearing

Rotor Position Estimation Strategy for Self-Sensing Active Magnetic Bearing Considering Eddy Currents

Dynamic Stiffness Analysis and Experimental Verification of Axial Magnetic Bearing Based on Air Gap Flux Variation in Magnetically Suspended Molecular Pump

Stability and Control for Cutting Chatter Based on Active Magnetic Bearings

Cooperative Rotor Position Estimation of Active Magnetic Bearings with Unsaturated Magnetic Bias