Abstract:The current-carrying arc is a critical factor that affects the electrical contact performance and material damage of contact pairs. In this study, a copper disk–copper disk pair was used to simulate the rolling electrical joint in a conductive rotating joint. Under operating conditions with a current of 2 A, rotation speeds from 4 to 600 r/min, and loads from 40 to 180 N, the dynamic behavior of the current-carrying arc and the surface damage mechanism were investigated. The movement characteristics of the arc at the friction interface were observed, and the arc generation difficulty and intensity were statistically analyzed based on the arc burning rate and arc energy. With increasing load and rotation speed, the generation of current-carrying tribological arcs became easier, and both the arc burning rate and arc energy increased. After the arc was generated, the arc root position was randomly distributed at the contact interface, exhibiting dynamic phenomena such as splitting and merging. Following the generation of the arc, the dominant damage mechanism at the current-carrying friction interface transitioned from mechanical damage to electrical damage. The manifestations of electrical damage included burning, oxidation, and roughening, with the degree of electrical damage positively correlated with the arc burning rate and arc energy. Surface oxidation could reduce the adhesion between metal contact pairs, contributing to a decrease in the current-carrying friction coefficient. Simultaneously, the film resistance caused by oxidation and the contraction resistance caused by roughening could lead to an increase in the average contact resistance.

Numerical simulation on the effect of current intensity on electrical contact performance of electrical connectors subject to micro-slip wear

Numerical Study of Coupled Electrical-Thermal-Mechanical-Wear Behavior in Electrical Contacts

Influence of the Interface Temperature on the Damage Morphology and Material Transfer of C–Cu Sliding Contact under Different Current Amplitudes

Effect of Electrical Current Density, Apparent Contact Pressure, and Sliding Velocity on the Electrical Sliding Wear Behavior of Cu–Ti3AlC2 Composites

Prediction of Electrical Contact Endurance Subject to Micro-Slip Wear Using Friction Energy Dissipation Approach

Effects of Current Load on Wear and Melt Erosion of Electrical Contacts under Fretting Condition

Research of Friction and Wear Behavior of Sliding Contacts under Strong Current Conditions

Current-carrying Wear Behavior and the Interface Evolution of the Cu/Al Tribological Pair

Effect of Surface Micro-parameters on Contact Temperature of Sliding Electrical Contact

Influence of electric current on the temperature rise and wear mechanism of copper-graphite current-carrying friction pair

Tribology performance of Cu-C/C composites with and without current

A Numerical Method to Investigate the Effect of Thermal and Plastic Behaviors on the Evolution of Sliding Wear

Modeling 3D Sliding Electrical Contact Considering Fully Coupled Thermal-Mechanical-electrical Effects

Current-carrying Tribological Behavior and Wear Mechanism of CuW Composites with Different W Content

Numerical Study on Wear Evolution and Mechanical Behavior of Steel Wires Based on Semi-Analytical Method

Study the influence of power-current impact with different conditions on the current-carrying wear property of carbon brush/friction disc contact

ANSYS-Based Simulation and Analysis of Contact Insertion and Temperature Characteristics of Contacts

Effect of the Contact Load and Rotation Speed on the Formation of Rolling Current-Carrying Arc and the Corresponding Material Damage

Study on Current-Carrying Tribological Characteristics of C-Cu Sliding Electric Contacts under Different Water Content

Effect of Electrical Current on Tribological Property of the Mo2C Modified C/C-Cu Composite

Effect of Electrical Current on the Tribological Property of Cu-Graphite Brush