Abstract:Zhang et al. (2006) utilized computational fluid dynamics (CFD) to examine the validity of erosion models that have been implemented into CFD codes to predict solid-particle erosion in air and water for inconel 625. This work is an extension of Zhang’s work and is presented as a step toward obtaining a better understanding of the effects of fluid viscosity and sand-particle size on measured and calculated erosion ratios, where erosion ratio is defined as the ratio of mass loss of material to mass of solid particles. The erosion ratios of aluminum 6061-T6 were measured for direct impingement conditions of a submerged jet. Fluid viscosities of 1, 10, 25, and 50 cP and sand-particle sizes of 20, 150, and 300 μm were tested. The average fluid speed of the jet was maintained at 10 m/s. Erosion data show that erosion ratios for the 20- and 150-μm particles are reduced as the viscosity is increased, whereas, surprisingly, the erosion ratios for the 300-μm particles do not seem to change much for the higher viscosities. For all viscosities considered, larger particles produced higher erosion ratios, for the same mass of sand, than smaller particles. Concurrently, an erosion equation has been generated based on erosion testing of the same material in air. The new erosion model has been compared to available models and has been implemented into a commercially available CFD code to predict erosion ratios for a variety of flow conditions, flow geometries, and particle sizes. Because particle speed and impact angle greatly influence erosion ratios of the material, calculated particle speeds were compared with measurements. Comparisons reveal that, as the particles penetrate the near wall shear layer, particles in the higher viscosity liquids tend to slow down more rapidly than particles in the lower viscosity liquids. In addition, CFD predictions and particle-speed measurements are used to explain why the erosion data for larger particles is less sensitive to the increased viscosities.

Dual role of microparticles in synergistic cavitation–particle erosion: Modeling and experiments

Research on Synergistic Erosion by Cavitation and Sediment: A Review

Numerical study of the synergistic effect of cavitation and micro-abrasive particles

Enhancement of cavitation intensity and erosion ability of submerged cavitation jet by adding micro-particles

Interaction between Micro-Particales and Bubbles in Cavitation-Erosion of Hydro-Machinery

An Erosion Model for the Discrete Element Method

Key Roles of Micro-Particles in Water on Occurrence of Cavitation-Erosion of Hydro-Machinery

A review of microscopic interactions between cavitation bubbles and particles in silt-laden flow

Study On Effect Of Microparticle'S Size On Cavitation Erosion In Solid-Liquid System

Experimental study on the interaction of a cavitation bubble flanked by two particles

Physics of cavitation near particles

Interaction of particles with a cavitation bubble near a solid wall

Velocity estimation of micro-particles driven by cavitation bubble collapses through controlled erosion experiments

Experimental Study of Cavitation Erosion Damage Affected by Microparticles

An Improved Eulerian-Lagrangian Method Combined with Ductile Material Model for Cavitation Erosion Assessment

Erosion characteristics and failure mechanism of reservoir rocks under the synergistic effect of ultrasonic cavitation and micro-abrasives

Effect of Microparticle Properties on Erosion in Solid-Steam Mixtures

Modeling of Solid Particle Erosion for a Water–Sand Impingement System Using OpenFOAM

Numerical Study of Solid Particle Erosion in a Cavity with Different Wall Heights

Experimental and Computational Investigations to Evaluate the Effects of Fluid Viscosity and Particle Size on Erosion Damage

Experimental study on the mesoscale causes of the effect of sediment size and concentration on material cavitation erosion in sandy water