Abstract:Laser Induced Graphene (LIG) is formed through Kraft paper pyrolysis, varying power and speed parameters. Achieving low sheet resistance and favorable morphology, the LIG proved suitable for conductive tracks in resistive heater applications. Results highlighted precise temperature control and rapid responses, demonstrating proof of concept with potential for real‐world applications. Additionally, life cycle assessment demonstrated significantly reduced environmental impact. Laser induced graphene (LIG), prepared directly with an in situ synthesis method onto Kraft Paper substrates, is proposed for the manufacture of biodegradable electronic devices. The investigation explores the influence of laser power and scanning speed on the properties of LIG conductive tracks and a sheet resistance of up to 0.25 kΩ sq−1. Raman spectroscopy and microscopy is used to analyse the interfacial properties, in particular the transition of cellulose fibers to carbonized graphene flakes through photothermal pyrolysis, leading to the formation of coral‐like structures. To demonstrate the applicability of the approach, flexible resistive heaters have been manufactured and tests show rapid heating with a homogeneous distribution and a maximum temperature of 145.5 °C. Additionally, an electro‐thermal conversion efficiency (hr+c) of 17.05 mW (°C cm2)−1 is achieved. Finally, a comparative Life Cycle Assessment with FR‐4 based electronics has been undertaken and the environmental impacts are calculated. The impact assessment shows a two magnitude lower impact on the environment for most categories, which suggests the approach is beneficial for the environment at a global production level. The results show that the photothermal pyrolysis of Kraft paper using a laser diode allows for low‐impact devices flexible and green electronics products.

Flexible Thermistors based on Laser-Induced Graphene from Polyetherimide

A flexible strain sensor from polypyrrole-coated fabrics

Facile and Cost-Effective Fabrication of Highly Sensitive, Fast-Response Flexible Humidity Sensors Enabled by Laser-Induced Graphene

High-linearity graphene-based temperature sensor fabricated by laser writing

Laser-Induced Graphene Based Flexible Electronic Devices

Laser-Induced Graphene Electrodes on Poly(ether–ether–ketone)/PDMS Composite Films for Flexible Strain and Humidity Sensors

Accurate Flexible Temperature Sensor Based on Laser-Induced Graphene Material

Highly conductive laser-induced graphene through the deposition of liquid metal particles for flexible electronics

Stretchable Graphene Thermistor with Tunable Thermal Index.

Flexible Copper-Based Thermistors Fabricated by Laser Direct Writing for Low-Temperature Sensing

Flexible Wearable Strain Sensors Based on Laser-Induced Graphene for Monitoring Human Physiological Signals

Full‐Range On‐Body Strain Sensor of Laser‐Induced Graphene Embedded in Thermoplastic Elastomer via Hot Pressing Transfer for Monitoring of the Physiological Signals

Green, Biodegradable, and Flexible Resistive Heaters‐Based Upon a Novel Laser‐Induced Graphene Manufacturing Process

A Flexible Temperature Sensor Array with Polyaniline/Graphene–Polyvinyl Butyral Thin Film

Ultrahigh Sensitivity of Flexible Thermistors Based on 3D Porous Graphene Characterized by Imbedded Microheaters

Multifunctional Flexible Sensor Based on Laser-Induced Graphene

Multifunctional Motion Sensing Enabled by Laser-Induced Graphene

Fabrication of Laser-Induced Graphene Based Flexible Sensors Using 355 nm Ultraviolet Laser and Their Application in Human–Computer Interaction System

Facile fabrication of a fast-response flexible temperature sensor via laser reduced graphene oxide for contactless human-machine interface

Flexible humidity sensor based on crosslinked polyethyleneimine/tannic acid and porous carbonaceous interdigitated electrode

Flexible and Stretchable Temperature Sensors Fabricated Using Solution‐Processable Conductive Polymer Composites