Abstract:This paper investigates the physical properties of Cu 0.6 Mg 0.2 Co 0.2 FeCrO 4 spinel ferrite produced by the sol-gel method and calcined at 850 °C. Our specimen possesses a cubic structure with space group. We detect the presence of small amount of Fe 2 O 3 . Our sample exhibited lattice parameters where a , b , and c were all equal to 8.3506 Å, and the cell volume was 582.307 Å 3 . Then, the spectrum demonstrated good refinement analysis, with a χ 2 factor of 1.66. Subsequently, the Debye–Scherrer equation provided a grain size of 88.18 nm. However, the grain size determined by the Williamson-Hall method resulted was 96 nm. Morphological analysis indicated that our sample consists of micro-sized grains equal to 2.62 μm. The dielectric analysis was carried out from 300 to 600 K, while measurements were taken over a wide frequency range from 10 2 to 10 6 Hz. Examination of the relaxation time and AC conductivity revealed that the same charge carriers could be responsible for both the relaxation and conduction mechanisms. The increase in conductivity at high-frequency can be attributed to the influence of charge carrier mobility through different localized states. This force also promotes the release of confined charges from different trapping sites. The overlapping-large polaron tunneling (OLPT) and Correlated Barrier Hopping (CBH) models were utilized to clarify the observed conduction mechanism. Furthermore, at lower frequencies, the sample exhibited higher real impedance values. Then, as the frequency rose, the Z ′ values decreased because more charge entities were transported, leading to a reduction in the concentration of trapped electric charge. The changes observed in Z ′′ suggest the emergence of the relaxation process. The Nyquist diagram was adjusted from 0 to 5 × 10 7 to understand the equivalent circuit in our system. Then, the conduction mechanism in the sample is influenced by the contributions of both grain and grain boundaries. At low frequencies, the ε ′ and ε ′′ values showed a significant rise and gradually decreased with increasing frequency, indicating that the sample is suitable for high-frequency applications. The decrease in ε ′ and ε ′′ values was more pronounced at lower frequencies than at higher frequencies. This behavior can be adequately explained using Maxwell and Wagner's expression, which is in line with Koops' theory, providing a coherent justification for the observed trends. The value of M ′ rose with frequency independently of temperature, approaching a plateau at a maximum asymptotic value. This saturation phenomenon indicates that charge carriers move over short distances during the conduction process. The Kohlrausch, Williams, and Watts functions were used to fit imaginary electrical modulus spectra. This revealed the non-Debye nature of the relaxation mechanism in the material.

Spinel M0.5Zn0.5Fe2O4 (M = Ni, Co, and Cu) ferrites for energy storage applications: Dielectric, magnetic and electrochemical properties

Synthesis, structural and opto-electrical/electronic trends of Zn/Co substituted spinel ferrites for energy conservation and supercapacitor applications

Prediction study of structural, thermal, and optical characterization of Co0.6Zn0.4Fe2O4 cubic spinel synthesized via sol–gel method for energy storage

Spinel ferrites having conductive grains, resistive interfacial boundaries and relaxation mechanism for possible supercapacitor applications

A detailed investigation of rare earth lanthanum substitution effects on the structural, morphological, vibrational, optical, dielectric and magnetic properties of Co-Zn spinel ferrites

Investigation of Crystallographic, Morphological, Magnetic and Electrochemical Properties of La‐Doped Cu‐CoFe2O4 Spinel Ferrites

Study of Thermal, Microstructural, Optical, Dielectric, and Magnetic Characterizations of Ni–Fe Spinel Cobaltite for Various Applications

Zn/Ba nanoparticles doping effect on Surface interface, Morphology, and Dielectric Elucidation of Spinel Ferrites

Chemical synthesis of Mg0.8Zn0.2SmxFe2−xO4 nanoparticles structural characterization, optical studies, electromagnetic properties, and applications

Eu3+ ions doped Cu1−xCoxEu0.025Fe1.975O4 spinel ferrite nanocrystals: insights on structural, cation distribution, magnetic properties, and switching field distribution

Detailed analysis of structural and optical properties of spinel cobalt doped magnesium zinc ferrites under different substitutions

Impact of nickel substitution on structural, dielectric, magnetic, and electrochemical properties of copper ferrite nanostructures for energy storage devices

Strong correlation of electrical transport and magnetic properties to ionic states, structure, and morphology of Al-substituted Ni–Co ferrite systems: A comprehensive study

Tuning Nickel Spinel Ferrite Using Mn-Li Ion as Dopant for Potential Applications in Various Devices

Syntheses and Magnetic Properties of Spinel-Type MFe2O4 (M=Ca, Mg, Cu, Zn) Nanocrystalline Powders

Synthesis and investigation of structural, elastic, and electrical properties of cobalt and magnesium substituted Ni-Zn spinel ferrite nanoparticles

Structural and magnetic behaviour of temperature influenced Mn0.5Zn0.25Cu0.25Fe2O4 spinel nanoparticles by co-precipitation route

Dielectric and structural properties of Co0.6Zn0.4Fe2O4 nanoferrites: sol–gel synthesis

Manganese doped cobalt–nickel spinel ferrite via. sol–gel approach: Insight into structural, morphological, magnetic, and dielectric properties

Experimental study of electrical and dielectric properties of Cu0.6Mg0.2Co0.2FeCrO4 spinel ferrite

Study of spinel ferrites with addition of small amount of metallic elements