Abstract:A radio-frequency micro-electro-mechanical system (RF MEMS) wafer-level packaging (WLP) method using pre-patterned benzo-cyclo-butene (BCB) polymers with a high-resistivity silicon cap is proposed to achieve high bonding quality and excellent RF performance. In this process, the BCB polymer was pre-defined to form the sealing ring and bonding layer by the spin-coating and patterning of photosensitive BCB before the cavity formation. During anisotropic wet etching of the silicon wafer to generate the housing cavity, the BCB sealing ring was protected by a sputtered Cr/Au (chromium/gold) layer. The average measured thickness of the BCB layer was 5.9 mu m. In contrast to the conventional methods of spin-coating BCB after fabricating cavities, the pre-patterned BCB method presented BCB bonding layers with better quality on severe topography surfaces in terms of increased uniformity of thickness and better surface flatness. The observation of the bonded layer showed that no void or gap formed on the protruding coplanar waveguide (CPW) lines. A shear strength test was experimentally implemented as a function of the BCB widths in the range of 100-400 mu m. The average shear strength of the packaged device was higher than 21.58 MPa. A RF MEMS switch was successfully packaged using this process with a negligible impact on the microwave characteristics and a significant improvement in the lifetime from below 10 million to over 1 billion. The measured insertion loss of the packaged RF MEMS switch was 0.779 dB and the insertion loss deterioration caused by the package structure was less than 0.2 dB at 30 GHz.

BCB Based Packaging for Low Actuation Voltage RF MEMS Devices

Development and Modeling of a Wafer-Level BCB Packaging Method for Capacitive RF MEMS Switches

Process Development of A New Tgv Interposer for Wafer Level Package of Inertial Mems Device

Wafer-Level Packaging Method For Rf Mems Applications Using Pre-Patterned Bcb Polymer

Packaging of RF Mems Switching Functions on Alumina Substrate

A Novel Wafer Level Package Strategy For Rf Mems

Wafer Level Micropackaging for RF MEMS Switches

Parasitic Effects Reduction for Wafer-Level Packaging of RF-Mems

A Pre-Shaped Wafer Level Packing Strategy for Rf Mems

Low stress packaging of a micromachined accelerometer

Research status of wafer level packaging for RF MEMS switches

New Low-Cost MEMS Capacitive Pressure Sensor Concept

Design and Fabrication of a Low Insertion Loss Capacitive RF MEMS Switch with Novel Micro-Structures for Actuation

Design, optimization and simulation of a low-voltage shunt capacitive RF-MEMS switch

High Vacuum Packaging of MEMS Devices Containing Heterogeneous Discrete Components

Smart packaging of electronics and integrated MEMS devices using LTCC

Analysis of Novel Packaging Techniques for High Power Electronics in SiC

Chip Level Packaging for Mems Using Silicon Cap

Wafer-Level Self-Packaging Design and Fabrication of MEMS Capacitive Pressure Sensors

An Analytical Model for High Performance Capacitive RF MEMS Switch Design

Bonding Packaging Of A Sp4t Rf Mems Switch