Abstract:As HDS catalysts, the supported catalysts including oxide state Mo, Co–Mo and sulfide state Mo on carbon nanotube (CNT) were prepared, while the corresponding supported catalysts on γ-Al2O3 were prepared as comparison. Firstly, the dispersion of the active phase and loading capacity of Mo species on CNT was studied by XRD and the reducibility properties of Co–Mo catalysts in oxide state over CNTs were investigated by TPR while the sulfide Co–Mo/CNT catalysts were characterized by XRD and LRS techniques. Secondly, the activity and selectivity of hydrodesulfurization (HDS) of dibenzothiophene with Co–Mo/CNT and Co–Mo/γ-Al2O3 were studied. It has been found that the main active molybdenum species in the oxide state MoO3/CNT catalysts were MoO2, rather than MoO3 as generally expected. The maximum loading before formation of the bulk phase was lower than 6%m (calculated in MoO3). The TPR studies revealed that that active species in oxide state Co–Mo/CNT catalysts were more easily reduced at relatively lower temperatures in comparison to those in Co–Mo/γ-Al2O3, indicating that the CNT support promoted the reduction of active species. Among 0–1.0 Co/Mo atomic ratio on Co–Mo/CNT, 0.7 has the highest reducibility. It shows that the Co/Mo atomic ratio has a great effect on the reducibility of active species on CNT and their HDS activities and that the incorporation of cobalt improved the dispersion of molybdenum species on CNT and mobilization. It was also found that re-dispersion could occur during the sulfiding process, resulting in low valence state Mo3S4 and Co–MoS2.17 active phases. The HDS of DBT showed that Co–Mo/CNT catalysts were more active than Co–Mo/γ-Al2O3 and the hydrogenolysis/hydrogenation selectivity of Co–Mo/CNT catalyst was also much higher than Co–Mo/γ-Al2O3. For the Co–Mo/CNT catalysis system, the catalyst with Co/Mo atomic ratio of 0.7 showed the highest activity, whereas, the catalyst with Co/Mo atomic ratio of 0.35 was of the highest selectivity.

N-octyltrimethylammonium bromide-assisted self-assembly of CoMo precursors to prepare CoMoS/Al 2 O 3 catalysts for highly selective hydrodesulfurization of thiophene

Synthesis of Novel NiMo Catalysts Supported on Highly Ordered TiO2-Al2O3 Composites and Their Superior Catalytic Performance for 4,6-Dimethyldibenzothiophene Hydrodesulfurization

Catalytic Characteristics of Active Corner Sites in CoMoS Nanostructure Hydrodesulfurization – A Mechanism Study Based on DFT Calculations

Role of the Solvent Evaporating Temperature on the NiMo/TiO2-Al2O3 Catalyst and the Hydrodesulfurization Performance for 4,6-Dimenthyldibenzothiophehe

Precise Tuning the CoMoOx/Al2O3 and CoMoSx/Al2O3 Interfacial Structures for Efficient Hydrodesulfurization of Dibenzothiophene

Electronic structure regulation of CoMoS catalysts by N, P co-doped carbon modification for effective hydrodesulfurization

Synthesis of alumina-nitrogen-doped carbon support for CoMo catalysts in hydrodesulfurization process

Influence of Active Phase Structure of CoMo/Al2O3 Catalyst on the Selectivity of Hydrodesulfurization and Hydrodearomatization

Enhanced hydrodesulfurization activity of thiophene over hollow tubular CoMo unsupported catalysts

Construction of High Content CoMoS Active Sites Through the Combination of Co 5 Mo 10 Molecular Precursors and Inert Carbon Matrix Support for Deep Hydrodesulfurization

Hydrodesulfurization of Thiophene in n-Heptane Stream Using CoMo/SBA-15 and CoMo/AlSBA-15 Mesoporous Catalysts

Mg-modified CoMo/Al2O3 with enhanced catalytic activity for the hydrodesulfurization of 4, 6-dimethyldibenzothiophene

A novel and facile strategy for the preparation of highly reactive NiMo/γ-Al 2 O 3 hydrodesulfurization catalyst

Catalytic Performance in Hydrodesulfurization of Thiophene and Ir Investigation of Co and No Adsorption over Co−Mo/Al 2 O 3 and Ru−Co−Mo/Al 2 O 3 Catalysts

Synthesis of cube MgO@AC and catalytic performance of its supported CoMo for hydrodesulfurization of 4,6-dimethyldibenzothiophene

CoMoS HDS catalysts supported on hierarchical halloysite and MCM-41 core-shell composite: Structural features and catalytic behavior study

States of Carbon Nanotube Supported Mo-Based HDS Catalysts

Improving Both the Activity and Selectivity of CoMo/δ-Al 2 O 3 by Phosphorous Modification for the Hydrodesulfurization of Fluid Catalytic Cracking Naphtha

Identification of Co–O–Mo Active Centers on Co-Doped MoS<sub>2</sub> Electrocatalyst

Identification of Co-O-Mo Active Centers on Co-Doped MoS2 Electrocatalyst

Synthesis, characterization, and performance evaluation of unsupported tetrametallic CoMoMnAl and CoMoZnAl catalysts for selective hydrodesulfurization (HDS)