Abstract:<p>Modern electronic devices with high heat flux increasingly exceed the capability of thermal management method. Two-phase thermal dissipation devices such as vapor chambers offer effective method for high heat flux cooling. Various new structural designs of vapor chambers are used as effective thermal control methods for high heat flux devices. However, the optimization criteria for the capillary wick structures are different. The combinations between the structural surface parameters and pore size of the capillary wick are different, while their influence on the heat transfer performance need to be studied. In this work, it is reported that the fabrication and thermal performance of vapor chambers with multi-layer sintered wicks and multi-artery wick design for liquid supply. We numerically and experimentally characterize the two types of sintered multi-artery wick for replenishing liquid and escaping vapor effectively with high heat flux. Three kinds of combinations of different copper particle sizes were applied to the sintered wicks in order to balance the liquid collecting rate and flow resistance. The copper particles of large particle size (60 μm /100 μm /150 μm) in the upper layer wick and copper particles of small particle size (30 μm /50 μm /100 μm) the lower layer wick were applied in the vapor chambers. In the present study, as an evaluation criteria for capillary wick designs, the relationship between surface porosity, surface area and critical heat flux was analyzed to obtain the experimental optimization of structural design and pore size combination as 50/100 μm. It was found that with similar multi-artery structure wicks, higher surface area porosity can effectively increase the critical heat flux of the vapor chambers. Judging from the experiment results, the minimum through-plane direction heat transfer resistance of the vapor chamber is 0.1426 K/W, the minimum in-plane direction heat transfer resistance is 0.016 K/W, while the critical heat flux of the vapor chamber is 262 W/cm<sup>2</sup>.</p>

Experimental study of a bilayer ceramic wick for the evaporator of a two-phase heat transfer device

Heat and Mass Transfer in the Porous Wick of a Capillary Evaporator

Biomimetic Micropillar Wick for Enhanced Thin-Film Evaporation

Thermal Performance of a Liquid-cooling Assisted Thin Wickless Vapor Chamber

Characterization of evaporation and boiling from sintered powder wicks fed by capillary action

Enhanced evaporation performance on a novel microstructured surface with vertical dimension gradient

Experimental Study on an Thermosyphon Loop with Bubble Pump Effect

Visualization experimental study on the boiling characteristics of vapor chamber evaporator surface with different heat sources

Numerical investigation on transient and steady phase change heat transfer in the evaporator of a loop heat pipe

Vapor chamber with two-layer liquid supply evaporator wick for high-heat-flux devices

Three-Dimensional Numerical Study on the Flow and Heat Transfer in Wick of Loop Heat Pipe

Superior Heat and Mass Transfer Performance of Bionic Wick with Finger-like Pores Inspired by the Stomatal Array of Natural Leaf

Experimental research on the thermal performance of a flat evaporator loop heat pipe with a new composite wick

Characterization of capillary performance of composite wicks for two-phase heat transfer devices

Cooling performance of a wick consisting of closely packed rods at moderately high heat loads

Effect of low thermal conductivity wick on the performance of compact loop heat pipe

Performance tests on triple composite mesh-groove-powder wicks in a visualizable flat-plate heat pipe

Study of the Natural Circulation Flow Boiling Heat Transfer Based On Partially Superhydrophilic Surface Modification

Investigation on Heat and Mass Transfer in A Evaporator of A Capillary-Pumped Loop with the Lattice Boltzmann Method: Pore Scale Simulation

Application of bio-wick in compact loop heat pipe