Abstract:Based on the sulfurization route treated with direct metal surface elemental reaction solution, the continuous dense Ag2S films of different thicknesses were prepared on glass substrates, showing the best thermoelectric properties of such materials so far, the zT reaches 0.83 ± 0.30 near 600 K. Silver sulfide thin film, with excellent thermoelectric properties, is few reported due to the complex and time‐consuming high‐temperature or high‐pressure synthesis process. Here, a fast ionic conductor n‐type Ag2S film with good crystallinity and uniform density is prepared by sputtering metal Ag films of different thicknesses on glass and then reacting in S precursor solution at low temperature. At 450 K, β‐Ag2S films can be obtained and underwent a phase transition from α‐Ag2S monoclinic, which had a significant effect on their electrical and thermal properties. The grain size of Ag2S films increases with the increase of film thickness. Before and after the phase transition, the carrier concentration and mobility cause obvious changes in the electrical properties of Ag2S. The carrier concentration of body‐centered cubic phase β‐Ag2S is about three orders of magnitude higher than that of monoclinic phase α‐Ag2S, and the mobility is also 2–3 times that of the latter. Especially, after the phase transition, the conductivity of β‐Ag2S rises exponentially from the zero conductivity of α‐Ag2S and increases with the increase of temperature. The Ag2S film shows the highest figure of merit of 0.83 ± 0.30 at 600 K from the sample with ∼1600 nm thickness, which is the highest record among Ag2S‐based thermoelectric materials reported so far.

Phonon drag thermopower persisting over 200 K in FeSb2 thin film on SrTiO3 single crystal

Unusual electronic and vibrational properties in the colossal thermopower material FeSb$_2$

Phonon-Drag Effect of Ultra-Thin Fesi2 and Mnsi1.7/Fesi2 Films

Phonon Drag Effect in Nanocomposite FeSb2

Enhancing thermoelectric performance of SrFBiS2−Se via band engineering and structural texturing

Transport and electrical properties of cryogenic thermoelectric FeSb2: the effect of isoelectronic and hole doping

Origin of efficient thermoelectric performance in half-Heusler FeNb_0.8Ti_0.2Sb

Optimizing the thermoelectric properties of flexible Bi[math]Sb[math]Te[math] thin films via modulating magnetron sputtering power

Hot Deformation Induced Defects and Performance Enhancement in FeSb2 Thermoelectric Materials

Thermoelectric Performance of Tetrahedrite (Cu 12 Sb 4 S 13 ) Thin Films: The Influence of the Substrate and Interlayer

Crystal Structure and Phonon Density of States of FeSi up to 120 GPa

High Power Factor and Thermoelectric Figure of Merit in Sb 2 Si 2 Te 6 through Synergetic Effect of Ca Doping

High Thermoelectric Power Factors in Plastic/Ductile Bulk SnSe2‐based Crystals

Modulated Fermi Level and Relaxed Lattice Strain Leading to Enhanced Thermoelectric Properties in AgSbSe 2

Realizing High Thermoelectric Properties in Bi2S3 Bulk via Band Engineering and Nanorods Compositing

Enhanced thermoelectric properties of FeTe 2 by Sb doping prepared by solid-state reaction

Significantly improved thermoelectric performance of Ag-doped Bi0.5Sb1.5Te3 films deriving from high-efficient carrier filtering effect

Half-Heusler alloys as emerging high power density thermoelectric cooling materials

Thermoelectric properties of Sb doped AlFe$_2$B$_2$

Structurally nanocrystalline electrically monocrystalline Sb2Te3 with high thermoelectric performance

In‐situ elemental reaction‐regulated Ag2S films enable the best thermoelectric performances