Abstract:This study presents a new fiber reinforced polymer tube/filling strengthening method (i.e., FRP tube/filling strengthening) that creates a new composite compression member with a novel mechanical behavior, "bilinear behavior." Previous experimental and theoretical studies have been conducted based on the ultimate state of the section. To thoroughly study the stiffness and entire loading process of this novel member, finite element analysis (FEA) models are built in this paper. First, the model development process considers the initial defections and interface properties, and these models are verified by the experimental results. Two models of typical load-axial displacement curves describe the experimental results: a Bilinear model and a Trilinear model. Second, finite element modeling (FEM) is used to conduct a parametrical analysis that considers 7 parameters, and the results identify the mechanism of the strengthened member. Specifically, the Bilinear model corresponds to an unreinforced or relatively weakly reinforced specimen, and the Trilinear model corresponds to a relatively strongly reinforced specimen. If the exterior restraint system is weak, then the core steel buckles and subsequently yields; this behavior is described by the Bilinear model. If the exterior restraint system is strong (e.g., the length or the bending stiffness of the exterior restraint system is great), then the specimen can continue to bear a higher force after steel yielding until elastic-plastic buckling occurs; this behavior is described by the Trilinear model. Third, the FEA results and previous experimental and theoretical studies are used to obtain the stiffness and load-axial displacement curves, which are helpful for the design process. In general, relatively accurate FEA models are built in this paper that are capable of describing the mechanical behaviors of the novel member.

A review of prediction methods for global buckling critical loads of pultruded FRP struts

ANALYSIS OF GLOBAL STABILITY OF C-PURLINS UNDER WIND SUCTION

A UNIFIED ANALYSIS METHOD FOR DISTORTIONAL AND GLOBAL BUCKLING OF Z-PURLINS IN FLEXURE

A unified analysis for distortional and lateral buckling of C-purlins in flexure

Analysis of global buckling of FRP pipes under axial compression

Evaluation and Modification of Bend Corner Strength Prediction Models of FRP Reinforcement

Isogeometric Method for Buckling Prediction and Post-Buckling Analysis of Variable Stiffness Composite Underwater Pressure Shell

Failure prediction of irregular arranged multi-bolt composite repair based on finite fracture mechanics model

EXPERIMENTAL STUDY ON BUCKLING RESISTANCE TECHNIQUE OF STEEL MEMBERS STRENGTHENED USING FRP

Theoretical Analysis and Design of Prestressed CFRP-Reinforced Steel Columns

Analysis of transverse compressive performance of pultruded glass fibre reinforced polymer

Prediction of Critical Buckling Load on Open Cross-Section Columns of Flax/PLA Green Composites

Intelligent prediction framework for axial compressive capacity of FRP-RACFST columns

Behavior Analysis of FRP Tube/filling Strengthened Steel Members under Axial Compression

Ultimate Conditions Prediction and Stress–Strain Model for FRP-Confined Concrete Using Machine Learning

Test and ultimate load capacity prediction of hat-stiffened composite panel under axial compression

Numerical studies on the performance of the circular fibre reinforced plastics-concrete filled steel tubes stub column under axial compression

Failure analysis of unidirectional fiber reinforced plastics based on computational micromechanics and PUCK failure theory

Accurate prediction of shear buckling capacity of low-yield-strength steel considering plastic deformations

Buckling Behavior of CFRP-aluminum Alloy Hybrid Tubes in Axial Compression

Enhanced Estimation of Axial Compressive Strength for CFRP Based on Microscale Numerical Simulation and the Response Surface Method