Abstract:This study presents a new fiber reinforced polymer tube/filling strengthening method (i.e., FRP tube/filling strengthening) that creates a new composite compression member with a novel mechanical behavior, "bilinear behavior." Previous experimental and theoretical studies have been conducted based on the ultimate state of the section. To thoroughly study the stiffness and entire loading process of this novel member, finite element analysis (FEA) models are built in this paper. First, the model development process considers the initial defections and interface properties, and these models are verified by the experimental results. Two models of typical load-axial displacement curves describe the experimental results: a Bilinear model and a Trilinear model. Second, finite element modeling (FEM) is used to conduct a parametrical analysis that considers 7 parameters, and the results identify the mechanism of the strengthened member. Specifically, the Bilinear model corresponds to an unreinforced or relatively weakly reinforced specimen, and the Trilinear model corresponds to a relatively strongly reinforced specimen. If the exterior restraint system is weak, then the core steel buckles and subsequently yields; this behavior is described by the Bilinear model. If the exterior restraint system is strong (e.g., the length or the bending stiffness of the exterior restraint system is great), then the specimen can continue to bear a higher force after steel yielding until elastic-plastic buckling occurs; this behavior is described by the Trilinear model. Third, the FEA results and previous experimental and theoretical studies are used to obtain the stiffness and load-axial displacement curves, which are helpful for the design process. In general, relatively accurate FEA models are built in this paper that are capable of describing the mechanical behaviors of the novel member.

Analysis of global buckling of FRP pipes under axial compression

Experimental Study on GFRP Pipes under Axial Compression

Study on Behaviors of FRP Confined Stub Concrete Filled Square Steel Tubes under Axial Load

Mechanical Analysis of Fiber Glass Reinforced Bonded Flexible Pipe Under External Pressure

Axial Compressive Strength Experimental and Numerical Studies of Full-Scale Specimens Simulating GFRP Composite Bushing Column

Nonlinear analysis of axial-compressed corroded circular steel pipes reinforced by FRP-casing grouting

Axial Compression Behavior of Pultruded GFRP Channel Sections

Structural Analysis of Fibreglass Reinforced Bonded Flexible Pipe Subjected to Tension

Investigation On Mechanical Properties Of Fiberglass Reinforced Flexible Pipes Under Bending

Analysis of transverse compressive performance of pultruded glass fibre reinforced polymer

A review of prediction methods for global buckling critical loads of pultruded FRP struts

LRFD Approach to CFRP Renewal of Prestressed Concrete Cylinder Pipes

Behavior of Cross Arms Inserted in Concrete-Filled Circular GFRP Tubular Columns

Experimental and numerical simulation on axial compression of GFRP-long-tube under quasi-static and dynamic loads

EXPERIMENTAL STUDY ON BUCKLING RESISTANCE TECHNIQUE OF STEEL MEMBERS STRENGTHENED USING FRP

EXPERIMENTAL AND ANALYTICAL EVALUATION OF LATERAL BUCKLING OF FRP COMPOSITE CANTILEVER I-BEAMS

Behavior Analysis of FRP Tube/filling Strengthened Steel Members under Axial Compression

An Analysis of the Flexural Stiffness and Horizontal Bearing Capacity of CFRP Composite Pipe Piles in Marine Environments

Experimental Study on Axial Compressive Behavior of Concrete-Filled FRP Filament-winded Tubes

Analysis of load carrying performance for glass fiber reinforced thermoplastic composite pipe under different in-service conditions

Analysis of the Mechanical Properties of a Fibreglass Reinforced Flexible Pipe (FGRFP)