Abstract:The stress wave generated by impact or dynamic load will produce significant reflection and transmission at the rock coal or rock interface during the propagation process. This will produce dynamic effects such as dynamic tensile, stress superposition and mutation. These dynamic effects will lead to obvious vibration at the interfaces, which is a key factor leading to dynamic damage and the failure of coal and rock mass. In the process of underground engineering excavation, the dynamic damage of a series of layered rock masses is one of the important factors causing geological disasters. Based on the two–dimensional similar material simulation experiment, the coal and rock mass combined of five layers of fine sandstone, medium sandstone, coal, coarse sandstone and mudstone was taken as the research object, and single and multi-point excitation (synchronous/step-by-step) were used to test the time–history vibration curves of rock–coal and rock–rock interfaces under impact load. It was concluded that the change of extreme value of vibration amplitude presented two stages: first increase, and then attenuation. Most of them required 2.25 cycles to reach the peak value, and the dynamic attenuation of amplitude conformed to the law of exponential. Based on Fast Fourier transform (FFT), the spectrum structures of the amplitude–frequency of interface vibration were studied, and the two predominant frequencies were 48.9~53.7 Hz and 92.4 Hz, respectively. Based on the Hilbert-Huang transform and energy equation, 5~7 vibration modes (IMF) were obtained by decomposing the time–history curves. The three modes, IMF1, IMF2, and IMF3, contained high energy and were effective vibration modes. IMF2 accounted for the highest proportion and was the main vibration mode whose predominant frequencies were concentrated in 45.6~50.2 Hz. Therefore, IMF2 played a decisive role in the whole vibration process and had an important impact on the dynamic response, damage and failure of coal and rock mass. In real conditions, the actual predominant frequencies can be converted according to the size and mechanical properties of the coal and rock mass, and the vibration response characteristics of the interfaces between coal and rock mass under impact load were preliminarily revealed. This study can provide reference for monitoring and early warning of coal and rock dynamic disasters, prevention and control of coal and gas outburst and technical development.

The strength characteristics and competitive failure mechanism of primary coal-rock combination considering interface damage quantity

Influence of coal-rock interface inclination on the damage and failure law of original coal-rock combination

Failure Characteristics of Combined Coal-Rock with Different Interfacial Angles

Experimental Study on the Influence of Lithology and Rock-Coal Height Ratio on Mechanical Properties and Impact Effect of Combined Body

Experimental Study on Mechanical Properties and Energy Evolution Law of Coal-Rock Composite Structure under Different Interface Connection Modes

Damage and energy characteristics of coal rock combinations with inclined coal seams under axial loading

Experimental and numerical investigation on the mechanical characteristics and failure mechanism of cracked coal & rock-like combined sample under uniaxial compression

Numerical study on damage response and failure mechanism of gas-containing coal-rock combination under confining pressure effect

Mechanical behaviors and failure characteristics of coal-rock combination under quasi-static and dynamic disturbance loading: a case based on a new equipment

Simulation Experimental Investigations into the Mechanical Response and Failure Mechanisms of Coal–Rock Combinations

Effect of Primary/Artificial Interface on Dynamic Failure Behavior of Combined Coal and Rock: Monitoring by High-Speed Imaging and Scanning Electron Microscopy

The failure behavior of coal-rock combined body under compression-shear loading

Failure energy evolution of coal–rock combination with different inclinations

Critical Conditions and Energy Transfer Characteristics of the Failure Process of Coal-Rock Combination Systems in Deep Mines

Failure characteristics and conditions of rock-coal combination structure with weak layer under dynamic and static stresses

Evolutionary mechanism of permeability of coal-rock combination considering interface effect: Model development and analysis

Deformation and Failure Behaviour of Coal-Backfilling Composite Structure Under Double Shearing

Internal stress transfer characteristics of coal–rock medium under concentrated force based on particle flow method

Mechanical characteristics underlying coal and rock combinations under different combination conditions

Vibration Response of the Interfaces in Multi-Layer Combined Coal and Rock Mass under Impact Load

Effect of Confining Pressure Unloading Rate on Mechanical and Energy Characteristics of Coal-Rock Combinations