Abstract:In this paper, we propose a two-bit reconfigurable intelligent surface (RIS)-aided communication system, which mainly consists of a two-bit RIS, a transmitter and a receiver. A corresponding prototype verification system is designed to perform experimental tests in practical environments. The carrier frequency is set as 3.5GHz, and the RIS array possesses 256 units, each of which adopts two-bit phase quantization. In particular, we adopt a self-developed broadband intelligent communication system 40MHz-Net (BICT-40N) terminal in order to fully acquire the channel information. The terminal mainly includes a baseband board and a radio frequency (RF) front-end board, where the latter can achieve 26 dB transmitting link gain and 33 dB receiving link gain. The orthogonal frequency division multiplexing (OFDM) signal is used for the terminal, where the bandwidth is 40MHz and the subcarrier spacing is 625KHz. Also, the terminal supports a series of modulation modes, including QPSK, QAM, etc.Through experimental tests, we validate a few functions and properties of the RIS as follows. First, we validate a novel RIS power consumption model, which considers both the static and the dynamic power consumption. Besides, we demonstrate the existence of the imaging interference and find that two-bit RIS can lower the imaging interference about 10 dBm. Moreover, we verify that the RIS can outperform the metal plate in terms of the beam focusing performance. In addition, we find that the RIS has the ability to improve the channel stationarity. Then, we realize the multi-beam reflection of the RIS utilizing the pattern addition (PA) algorithm. Lastly, we validate the existence of the mutual coupling between different RIS units.

Measurement-Based Small-Scale Channel Model for Sub-6 GHz RIS-Assisted Communications

Multi-Scenario Broadband Channel Measurement and Modeling for Sub-6 GHz RIS-Assisted Wireless Communication Systems

Wireless Communications Empowered by Reconfigurable Intelligent Surfaces: Model-based Vs Model-Free Channel Estimation

Time-Domain Channel Measurements and Small-Scale Fading Characterization for RIS-Assisted Wireless Communication Systems

Reconfigurable Intelligent Surfaces: Channel Characterization and Modeling

Field trial measurement and channel modeling for reconfigurable intelligent surface

A Statistical MIMO Channel Model for Reconfigurable Intelligent Surface Assisted Wireless Communications

Empirical Validation of the Impedance-Based RIS Channel Model in an Indoor Scattering Environment

Indoor and Outdoor Physical Channel Modeling and Efficient Positioning for Reconfigurable Intelligent Surfaces in mmWave Bands

Characterization of Indoor RIS-Assisted Channels at 304 GHz: Experimental Measurements, Challenges, and Future Directions

RIS-Aided Communications at 3.5GHz: Some Insights from Practical Measurement Results

Wireless Communications With Reconfigurable Intelligent Surface: Path Loss Modeling and Experimental Measurement

Path Loss Modeling and Measurements for Reconfigurable Intelligent Surfaces in the Millimeter-Wave Frequency Band

Large-Scale RIS Enabled Air-Ground Channels: Near-Field Modeling and Analysis

Reconfigurable Intelligent Surface Enhanced Massive IoT Systems with Nonlinear Measurements

A Generalized Model for RIS-Assisted Communications: On the Effect of Scattered Electromagnetic Wave

Reconfigurable Intelligent Surface (RIS) System Level Simulations for Industry Standards

RIS-Assisted MIMO Channel Modeling with Spatially Consistent Sparsified Properties

Modeling RIS from Electromagnetic Principles to Communication Systems--Part II: System-Level Simulation, Ray Tracing, and Measurement

Validating Properties of RIS Channel Models with Prototypical Measurements

Two-Bit RIS-Aided Communications at 3.5GHz: Some Insights from the Measurement Results Under Multiple Practical Scenes