Abstract:Electrical bearing currents may disturb the performance of the bearings via electro-corrosion if they surpass a limit of ca. 0.1 to 0.3 A/mm2. A continuous current flow, or, after a longer time span, an alternating current or a repeating impulse-like current, damages the raceway surface, leading in many cases to a fluting pattern on the raceway. Increased bearing vibration, audible noise, and decreased bearing lubrication as a result may demand a replacement of the bearings. Here, an electrically corroded axial ball bearing (type 51208) with fluting patterns is investigated. The bearing was lubricated with grease lubrication and was exposed to 4 A DC current flow. It is shown that the electric current flow causes higher concentrations of iron oxides and iron carbides on the bearing raceway surface together with increased surface roughness, leading to a mixed lubrication also at elevated bearing speeds up to 1500 rpm. The "electrically insulating" iron oxide layer and the "mechanically hard" iron carbide layer on the bearing steel are analysed by WLI, XPS, SEM, and EDS. White Light Interferometry (WLI) is used to provide an accurate measurement of the surface topography and roughness. X-ray Photoelectron Spectroscopy (XPS) measurements are conducted to analyze the chemical surface composition and oxidation states. Scanning Electron Microscopy (SEM) is applied for high-resolution imaging of the surface morphology, while the Focused Ion Beam (FIB) is used to cut a trench into the bearing surface to inspect the surface layers. With the Energy Dispersive X-ray spectrometry (EDS), the presence of composing elements is identified, determining their relative concentrations. The electrically-caused iron oxide and iron carbide may develop periodically along the raceway due to the perpendicular vibrations of the rolling ball on the raceway, leading gradually to the fluting pattern. Still, a simulation of this vibration-induced fluting-generation process from the start with the first surface craters—of the molten local contact spots—to the final fluting pattern is missing.

WLI, XPS and SEM/FIB/EDS Surface Characterization of an Electrically Fluted Bearing Raceway

Study on electric erosion in grease lubrication using optical interference method

A Study on Decisive Early Stages in White Etching Crack Formation Induced by Lubrication

Formation of Corrugated Damage on Bearing Race under Different AC Shaft Voltages

Investigation of Surface Integrity Induced by Various Finishing Processes of AISI 52100 Bearing Rings

Tribological and dynamic performance analysis of rolling bearings with varied surface textures operating under lubricant contamination

The effect of electrical current on premature failures and microstructural degradation in bearing steel

Rolling Element Bearing Damage in the Presence of Applied Electric Current

Fatigue Failure of High Precision Spindle Bearing under Extreme Service Conditions

Journal Bearing Wear Monitoring via On-Line Visual Ferrography

Current-carrying friction in carbon coated ball bearing

A Statistical Prediction of Electrical Discharge Initiation and Semi-Analytical Transient Mixed Lubrication Model of a Rolling Element

Microstructure Alterations and White Etching Area Formation in Bearing Steels under High-Frequency Dynamic Loading

Analysis and Evaluation of the Synergistic Effect of Ceramic Materials and Surface Texture on Anti-Abrasive Particle Wear under Rolling Conditions

Experimental investigations to assess surface fatigue failure in rolling contact bearing

Formation Mechanism and Influence of White Etching Area on Contact Fatigue Spalling of M50 Bearing Steel

Analysis and Evaluation of Multi-state Wear Mechanism of Elastic-flexible Thin-walled Bearings

Mechanisms of abrasive wear in lubricated contacts

Does laser surface texturing really have a negative impact on the fatigue lifetime of mechanical components?

Waviness Affects Friction and Abrasive Wear

The Evolution of White Etching Cracks (WECs) in Rolling Contact Fatigue-Tested 100Cr6 Steel