Abstract:The problem of electric rolling stock traction machinery failures caused by electrical erosion of bearings is addressed. Damages inflicted to traction machinery bearings as a result of electric current flowing through them have been known since long ago. In recent time, however, damages of this kind have become more frequent, because frequency and voltage converters for control of three-phase inductor motors are widely used in the electric rolling stock. An overview of factors causing the occurrence of stray currents generated in frequency converter driven traction motors and sources of these currents is presented. Electric current flows through rolling bearings in the area of the contact between the rolling elements with inner and outer rings, thus causing damage to the bearing metal components' rolling surfaces and degrading the quality of lubricants. To study and analyze the currents through bearings, the stray capacitances existing in traction machines are determined, and their calculation methods are defined, the necessity of which is stemming from the fact that these capacitances influence the generation of parasitic currents. The stray capacitances in traction machines include the capacitance between the stator windings and the stator core pack, the capacitance between the stator windings and the rotor, the capacitance between the rotor and the stator core pack, and the capacitances of the bearings. From the electrical point of view, bearings may also be regarded as capacitances. As long as there is a continuous lubricant film between the inner ring and outer rings and the rolling elements, the bearings behave as capacitors. A difference of potentials across the bearing elements may lead to electrostatic discharges and, hence, to discharge currents through the bearings. One of possible ways to enhance the reliability of traction machine bearing units is to use insulated bearings. The change in the impedance of bearings with ceramic coating and hybrid rolling elements depending on the applied voltage frequency and operating temperature is calculated and analyzed. Conclusions regarding the expediency of using hybrid bearings having rings made of bearing steel and rolling elements made of bearing silicon nitride (Si3N4) are drawn.

Rolling Element Bearing Damage in the Presence of Applied Electric Current

Electrical Bearing Damage, A Problem in the Nano- and Macro-Range

The effect of electrical current on premature failures and microstructural degradation in bearing steel

A Statistical Prediction of Electrical Discharge Initiation and Semi-Analytical Transient Mixed Lubrication Model of a Rolling Element

Damages on the lubricated surfaces in bearings under the influence of weak electrical currents

Motor Bearing Damage Induced by Bearing Current: A Review

WLI, XPS and SEM/FIB/EDS Surface Characterization of an Electrically Fluted Bearing Raceway

Formation of Corrugated Damage on Bearing Race under Different AC Shaft Voltages

An Analysis of Damages Inflicted to the Bearing of Rolling Stock Traction Machines Powered by Frequency and Voltage Converters

Electrical Bearing Failures in Electric Vehicles

Investigation of the Electrical Impedance Signal Behavior in Rolling Element Bearings as a New Approach for Damage Detection

Study on electric erosion in grease lubrication using optical interference method

Analysis of capacitive discharges in motor bearings under different operation conditions

Ways to Improve the Reliability of Bearings in Traction Induction Machines

A novel method for diagnosing rolling bearing surface damage by electric impedance analysis

Investigation of Bearing Current and Degradation in Wide Bandgap Inverter Fed Electric Machines

The effect of electrical current on lubricant film thickness in boundary and mixed lubrication contacts measured with ultrasound

The influence of various grease compositions and silver nanoparticle additives on electrically induced rolling-element bearing damage

Investigation of High‐speed Shaft Bearing Loads in Wind Turbine Gearboxes Through Dynamometer Testing

Generation conditions of rolling current-carrying associated arc on Cu-Cu pairs and the surface damage mechanisms

Experimental investigations to assess surface fatigue failure in rolling contact bearing