Abstract:Weakening the basal texture was a commonly used method to improve the ductility and formability of magnesium alloys. The easier activation of basal slip was often considered to be an important reason for the improved ductility of the weak basal textured magnesium alloys. However, basal slip alone cannot well satisfy the Von Mises criterion and its activation was nearly saturated in strong basal textured magnesium alloys. The deformation mechanisms of weak basal textured magnesium alloys are still open to debate. In this work, the Schmid Factor (SF) of the basal slip is obviously increased and a high fracture elongation of ∼35% is achieved in AZ31 alloy by careful tailoring of grain orientation and rational selection of loading direction. Grain size scale strain distribution by high-resolution digital image correlation (DIC) and slip activation based on the slip trace method were used to in-depth analyze the deformation mechanisms. Although the basal slip' average SF increases, the strain statistics show that the direct strain contribution of the basal slip to the deformation gets decrease, contrary to conventional expectation. This is mainly attributed to the coupling effect of the increased basal slip' SF with the large intergranular misorientation, which significantly promotes the activation of non-basal slip and increases its contribution to the deformation, thus leading to a lower direct strain contribution of the basal slip. The results of the study may help to further reveal the plastic deformation mechanism of magnesium alloys and improve the plasticity of magnesium alloys.

Enhanced ductility of Mg–1Zn–0.2Zr alloy with dilute Ca addition achieved by activation of non-basal slip and twinning

Enhanced ductility and strength of Mg-1Zn-1Sn-0.3Y-0.2Ca alloy achieved by novel micro-texture design

Deformation mechanisms of Mg-Ca-Zn alloys studied by means of micropillar compression tests

Enhanced strength-ductility synergy and activation of non-basal slip in as-extruded Mg–Zn–Ca alloy via heterostructure

Numerical study on the ductility improvement mechanism of dilute Mg-Ca alloys

Microstructure and mechanical properties synergistically enhanced via heat treatment modification of the as-extruded Mg-1.5Al-0.5Zn-0.2Y-0.2Ca alloy

Development of low-alloyed Mg–Zn–Ca–Sn–Mn alloy with high strength-ductility synergy by sub-rapid solidification and hot rolling

Improved Ductility of Mg–3Gd–0.6Zr Alloy by Cuboid-Shaped Phase: Experiments and First-Principle Calculations

Unveiling the ductility enhancement mechanisms in AZ31 magnesium alloy achieved via shear strain-assisted twin orientation regulation

Effect of Ca addition on microstructure and mechanical properties of Mg–3.8Al–1.1Sn alloys

Low-cost and high-strength Mg-Al-Ca-Zn-Mn wrought alloy with balanced ductility

Mechanistic investigation of a low-alloy Mg–Ca-based extrusion alloy with high strength–ductility synergy

Realizing impressive superplasticity in a low-alloyed Mg-Zn-Ca-Al-Mn alloy: The roles of grain boundary segregation and dense β-Mn particles

Revealing the influence of Zr micro-alloying and hot extrusion on a novel high ductility Zn–1Mg alloy

Towards strength-ductility synergy through a novel technique of multi-pass lowered-temperature drawing in AZ31 magnesium alloys

The balance between work hardening and softening behaviors of Mg-xZn-1Gd-0.2Ca-0.1Zr alloys influenced by trace Zn addition

Achieving excellent ductility with increased Schmid Factor but decreased direct strain contribution of basal slip in an intergranular misorientation tailored magnesium alloy

Novel Mg–Al–Sn–Zn–Y Alloys with Enhanced Strength−Ductility Combination Prepared by Hard‐Plate Rolling

Improvement of ductility and work hardening ability in a high strength Zn-Mg-Y alloy via micron-sized and submicron-sized YZn12 particles

Critical resolved shear stresses for slip and twinning in Mg-Y-Ca alloys and their effect on the ductility

Evading Strength-Ductility Tradeoff in Mg Alloy via Uniform Microstructure and Unique Texture Modification Induced by Moderate Temperature ECAP