Abstract:The central solenoid (CS) is the heart of the ITER tokamak and serves as a critical element in the ITER magnet system. The CS consists of six large high field superconducting magnets (Modules) approximately 4 meters in diameter and 2 meters tall that weigh approximately 110 metric tonnes each. The central solenoid modules (CSM) are being fabricated and tested at a manufacturing site in Poway, California. Upon completion of each module, they will be shipped from California, USA to the ITER facility in Cadarache, France by both land (girder truck) and ocean (freighter). The structurally flexible Helium (He) piping system and temporary instrumentation cable spool racks will experience deformations and stresses from a wide range of transport accelerations (harmonic and shock-type excitation). Design-basis static accelerations are adopted from applicable codes which envelop both land and water transport. Two finite element (FE) models developed in ANSYS are used to simulate the effects of these static accelerations on the CSM. Rigid body dynamics fundamentals help identify the importance of excitation and natural frequencies, shock load duration and transmissibility. Modal analysis estimates the response of the piping system to harmonic loads. Shock load transmission to the piping and spool rack are also assessed. FE models of the CSM He piping system and cable spool rack provide stress results developed from applied accelerations. The paper describes the assessments performed on the CSM piping and cable storage systems for various transport loads, prior to the shipment of the first CSM. Furthermore, the acceleration data collected from the successful transport of first three modules are evaluated with respect to implications for the CSM transport loads.

Acceptance Test of Pre-Compression Rings for ITER Magnet System

Installation Progress of the Central Solenoid (CS) on ITER Site

Completion and Factory Acceptance Test of ITER PF1 Coil

Design Evolution and Integration of the ITER In-Vessel Components

Delivered Poloidal Field Coils to ITER Fusion Tokamak Facility: Status, Factory Acceptance Test Results and Overview of the Undergone Electrical Tests in Manufacturing Processes

Overview of verification tests on AC loss, contact resistance and mechanical properties of ITER conductors with transverse loading up to 30 000 cycles

Manufacturing and testing of ITER FW CuCrZr/316L(N)-IG explosive Bi-metallic plates

Status of the ITER ion cyclotron heating and current drive system

Toward Completion and Delivery of the First EU ITER Magnets

Approaching ITER PF Coil Manufacturing

Manufacture and test of seismic bellows for ITER magnet feeder

The Toroidal Field Coils for the ITER Project

The Role of Advanced Modeling in the Assembly and Operation of Tokamak Magnets

Mechanical Tests of the ITER's PF-1 Coil Electrical Insulation Qualification Samples at 77 K

Proposal of Integrated Test Facility for in-Vessel Thermofluid Safety of Fusion Reactors

Structural Qualification of ITER Central Solenoid Module during Transport from California, USA to ITER Site

Evaluation of the Fretting Resistance of the High Voltage Insulation on the ITER Magnet Feeder Busbars

Radiofrequency and mechanical tests of silver coated CuCrZr contacts for the ITER ion cyclotron antenna

Test of PF1 Coil Electrical Joint

RADIOGRAPHIC TESTING BY COMPUTED RADIOGRAPHY (RT-CR) OF THE HELIUM INLET WELDS (HI) OF THE POLOIDAL FIELD COIL (PF1), PRODUCED BY JSC NIIEFA (SCIENTIFIC RESEARCH INSTITUTE OF ELECTROPHYSICAL APPARATUS) WITHIN THE FRAMEWORK OF THE INTERNATIONAL THERMONUCLEAR EXPERIMENTAL REACTOR (ITER) PROJECT