Abstract:The central solenoid (CS) is the heart of the ITER tokamak and serves as a critical element in the ITER magnet system. The CS consists of six large high field superconducting magnets (Modules) approximately 4 meters in diameter and 2 meters tall that weigh approximately 110 metric tonnes each. The central solenoid modules (CSM) are being fabricated and tested at a manufacturing site in Poway, California. Upon completion of each module, they will be shipped from California, USA to the ITER facility in Cadarache, France by both land (girder truck) and ocean (freighter). The structurally flexible Helium (He) piping system and temporary instrumentation cable spool racks will experience deformations and stresses from a wide range of transport accelerations (harmonic and shock-type excitation). Design-basis static accelerations are adopted from applicable codes which envelop both land and water transport. Two finite element (FE) models developed in ANSYS are used to simulate the effects of these static accelerations on the CSM. Rigid body dynamics fundamentals help identify the importance of excitation and natural frequencies, shock load duration and transmissibility. Modal analysis estimates the response of the piping system to harmonic loads. Shock load transmission to the piping and spool rack are also assessed. FE models of the CSM He piping system and cable spool rack provide stress results developed from applied accelerations. The paper describes the assessments performed on the CSM piping and cable storage systems for various transport loads, prior to the shipment of the first CSM. Furthermore, the acceleration data collected from the successful transport of first three modules are evaluated with respect to implications for the CSM transport loads.

Installation Progress of the Central Solenoid (CS) on ITER Site

Manifold concept design for ITER gas injection system

Structural Qualification of ITER Central Solenoid Module during Transport from California, USA to ITER Site

Design Evolution and Integration of the ITER In-Vessel Components

The ITER magnet systems: progress on construction

Approaching ITER PF Coil Manufacturing

Installation Design and Integration of Poloidal Field Converter Units for ITER

Progress of the ITER Correction Coils in China

Development of the Coil Terminal Boxes for the ITER Magnet Feeder Systems

The Toroidal Field Coils for the ITER Project

Completion and Factory Acceptance Test of ITER PF1 Coil

Toward Completion and Delivery of the First EU ITER Magnets

Mechanical performance evaluation of the CFETR central solenoid model coil design

From Design to Development Phase of the ITER Correction Coils

Full Scale Prototype Research and Development of the Iter Pf Converter Unit

Design and Development of Turn Insulation Automatic Wrapping System for CRAFT TF

The Mechanical Performance Analyses of CFETR CSMC Preload Components Under Testing Current

Final Design of ITER In-Vessel Coils and Manufacturing of In-Vessel Coil Conductor

A description of the ITER's gas injection systems and current R&D activities

Progress in Europe of the Procurement of the EU ITER TF Coils

About the First 6 Toroidal Field Coils and 2 Poloidal Field Coils Completed by EU for ITER