Abstract:The construction of a pipeline in mountainous terrain often exposes great challenges compared to that on flat land. To accommodate the terrain and resultantly complex route, the pipeline design must incorporate a large quantity of cold bends and elbow fittings. A recently constructed project provides a prime example of a pipeline crossing such terrain. The challenging construction conditions and the bends and elbows make the assessment of stress impacting long-term pipeline integrity critical, yet difficult. This paper focuses on three specific aspects of long-term integrity for construction in mountain areas using advanced finite element analysis (FEA).The first scenario is tie-in welding. Tie-in welding connects separate pipeline segments constructed independently. In general practice, considerable lengths of pipe are left unburied to reduce the potential resultant stress due to the misalignment between the pipes at the tie-in weld location. However, in mountainous terrain the length of unburied pipe may be constrained by field conditions of the tie-in location. The implications are amplified at a tie-in adjacent to bends or elbows.The second scenario is hydrostatic testing. The gravitational weight of water generates additional internal pressure in the pipeline segments at low elevations. In areas of significant elevation change, hydrostatic test section design defines the segments based on the maximum allowable hoop stress level calculated for straight pipe. However the bends and elbows often encounter increased combined stresses at such locations that may not be adequately considered.The last scenario is ratcheting. Exacerbated by complex routing and profile, pipelines constructed in mountainous areas are at risk to develop significant uplift in the soil at bend locations during hydrostatic testing and initial operating cycles. If such uplift displacement accumulates during subsequent operating cycles, a phenomenon known as ratcheting, the pipe may eventually fail by upheaval buckling.This paper evaluates the above scenarios of a NPS 30 section of pipeline consisting of several segments with wall thicknesses varying from 12.0 mm through 19.6 mm, and contains frequent bends and elbows. The pipeline route is mountainous with slopes exceeding 70 degrees, and includes a tunnel immediately adjacent to water crossings and steep slopes. Tie-in welds are made in tight confines at either end. Analysis based on this project profile provides detailed information and insight into the design and construction of pipelines in mountainous terrain.

Study on stress asymmetry of pipeline welded joint in mountainous areas with large slopes

Tunnelling-induced Response of a Jointed Pipeline and Its Equivalence to a Continuous Structure

Stress Analysis of the Effect of Additional Load on the Butt Weld of Suspended Pipeline With Variable Wall Thickness

Quantitative research on stress failure risk assessment for girth welds with unequal wall thickness of the X80 pipeline under lateral load

Pipeline Integrity Analyses For Construction In Mountainous Areas

Thermal, metallurgical and mechanical analysis of circumferentially multi-pass welded P92 steel pipes

Optimization and Stress Analysis of Underground Oil Pipelines in High and Steep Slope Areas

Buckling Response of Offshore Pipelines under Combined Tension and Bending

ANALYSIS OF STABILITY FAILURE FOR PIPELINE DURING LONG DISTANCE PIPE JACKING

Research On Safety Assessment Method For Pressure Pipe With Incomplete Welding Defects Under Complicated Loadings

Welding residual stress analysis of the X80 pipeline: simulation and validation

Analytical Solution for Upheaval Buckling of Shallow Buried Pipelines in Inclined Cohesionless Soil

Fracture behavior analysis of X80 pipelines welded joints with unequal wall thickness

Analytical Solution of Pipeline Upheaval Buckling Considering Bi-Linear Axial Pipe-Soil Interaction Model

A novel method for determining the stress-strain constitutive relationship of high-grade pipeline weld zone material

3D finite element analysis and optimization of welding residual stress in the girth joints of X80 steel pipeline

Effect of welding sequences and welding direction on the residual stress in X80 pipeline steel

Effect of welding axial stresses on the strength of a welded pipe joint with a defect

Experimental Study of Sandy Slope-Pipe Interaction under Loading

The Research on the Stress Analysis of Overhead Steam Pipeline

3D finite element simulation on stress-strain distributions in all position root butt welding of pip