Analysis of quantum conductance of carbon nanotube junctions by the effective mass approximation

Ryo Tamura,Masaru Tsukada
DOI: https://doi.org/10.1103/PhysRevB.58.8120
1998-07-29
Abstract:The electron transport through the nanotube junctions which connect the different metallic nanotubes by a pair of a pentagonal defect and a heptagonal defect is investigated by Landauer's formula and the effective mass approximation. From our previous calculations based on the tight binding model, it has been known that the conductance is determined almost only by two parameters,i.e., the energy in the unit of the onset energy of more than two channels and the ratio of the radii of the two nanotubes. The conductance is calculated again by the effective mass theory in this paper and a simple analytical form of the conductance is obtained considering a special boundary conditions of the envelop wavefunctions. The two scaling parameters appear naturally in this treatment. The results by this formula coincide fairly well with those of the tight binding model. The physical origin of the scaling law is clarified by this approach.
Mesoscale and Nanoscale Physics
What problem does this paper attempt to address?
The problem that this paper attempts to solve is the electron transport characteristics in carbon nanotube junctions, especially the conductance behavior when different metallic nanotubes are connected through a pair of pentagon defects and heptagon defects. Specifically, the authors hope: 1. **Understand and explain the scaling laws found in previous studies**: Previous research has shown that the conductance of nanotube junctions is almost determined by only two parameters, namely the ratio of energy to the multi - channel starting energy and the ratio of the radii of the two nanotubes. The authors hope to reproduce this scaling law through the effective - mass approximation theory and provide a physical explanation. 2. **Derive an analytical expression for conductance**: By introducing special boundary conditions, the authors hope to obtain a simple analytical form to describe conductance, so as to better understand the physical mechanisms behind it. 3. **Verify the consistency with the tight - binding model results**: By comparing the calculation results based on the effective - mass approximation with those of the tight - binding model, confirm whether the two are consistent and analyze the reasons for any differences. ### Overview of Main Content - **Background Introduction**: Since carbon nanotubes were discovered, they have attracted wide - spread interest as one - dimensional conductors at the nanoscale. Depending on the radius and helical angle of nanotubes, they can exhibit metallic or semiconducting properties. Therefore, it becomes possible to use metallic nanotubes as leads to construct nano - scale electronic devices. - **Problem Raising**: When metallic nanotubes of different diameters are connected through pentagon and heptagon defects to form junctions, what are the electron transport characteristics of these junctions? In particular, can conductance be described by the continuum theory? - **Methods and Results**: - Use the Landauer formula and the effective - mass approximation theory to calculate the conductance of nanotube junctions. - Derive an analytical expression containing two scaling parameters (energy ratio and radius ratio). - The results show that this analytical expression is in very good agreement with the numerical results of the tight - binding model, especially near the Fermi level. - **Conclusion**: Through the effective - mass approximation theory, the authors not only successfully reproduced the scaling laws observed in previous studies, but also provided a transparent and intuitive physical explanation. In addition, they also discussed the potential application of this theory in other related nanostructures. ### Formula Summary - **Analytical expression for conductance**: \[ \sigma=\frac{24}{\beta \sum_{i = 1}^{2}\sum_{j = 1}^{2}\left(\frac{3}{4}\right)^{i + j-2}X_{i,j}^2}+6 \] where, \[ X_{i,j}=\pi z_5\left[J_i(\beta z_5)N_j(z_5)-N_i(\beta z_5)J_j(z_5)\right] \] - **Simplified conductance expression (when \(E_F = 0\))**: \[ \sigma=\frac{8}{\beta^3+\beta^{-3}+2} \] These formulas show how conductance depends on the geometry and relative size of nanotubes, not just on atomic details.