Abstract:In Liquid Composite Molding (LCM), the fiber preform is placed in a mold and resin is injected through a gate to fill the empty spaces within the mold. LCM processes are modeled as resin flow through fibrous porous media in which if one knows the permeability values, one can determine the arrival times of the resin at any location. A mold with radial injection with 192 flow arrival detection sensors along 16 radial lines are mounted flush with the top and the bottom mold surface with an additional sensor on the top surface opposite to the injection hole of the bottom surface. The inverse problem addressed here is from the recorded resin arrival times at sensor locations, how accurately can one determine the permeability of the preform? The proposed method uses correlation between the experimentally recorded resin arrival times and 3D flow simulation of the experiment. The optimization routine varies the permeability components in the simulation to achieve the best possible match with the experimental arrival times at all the sensor locations. Currently, all in-plane permeability components and through-the thickness permeability are characterized from a single experiment with the potential to evaluate the cross-thickness off-diagonal terms as well. In addition, the technique also demonstrates how one can reduce the variation in through thickness permeability by the use of a distribution media at the injection hole to avoid blockage of the inlet by the fiber tows. The optimization routine sequentially optimizes the values of the individual components of the permeability tensor using golden search method, and then repeats the entire sequence until the best match is found. The validation and sensitivity of this method is explored and it has been shown that this technique is promising for characterization of all permeability components from a single radial flow experiment.

Numerical evaluation of the transverse permeability determination experiment

On the design of test molds based on unidirectional saturated flows to measure transverse permeability in liquid composite molding

Visualization And Quantification Of Forced In-Plane Flow Through Deformed Porous Media

Numerical Simulation of Melt Filling and Gas Penetration in Gas Assisted Injection Molding

Characterization of 3D fiber preform permeability tensor in radial flow using an inverse algorithm based on sensors and simulation

Simulation of Fiber Reinforced Composite Materials Mold Filling Process and Mechanical Properties Analysis

Effect of Layer Shifting on the Out-of-Plane Permeability of 0 degrees/45 degrees Alternative Multilayer Fabrics

A Numerical Study on the Influence of Strain Rate in Finite-Discrete Element Simulation of the Perforation Behaviour of Woven Composites

Investigation of Transport Property of Fibrous Media: 3D Virtual Modeling and Permeability Calculation

Permeability of Hybrid Reinforcements and Mechanical Properties of their Composites Molded by Resin Transfer Molding

Prediction of Permeability for Chemical Vapor Infiltration

Experimental Study on Permeability of L-type Preform for Vacuum Infusion Process

Numerical prediction strategy of fabric in‐plane permeability considering realistic inter‐ and intra‐tow geometry

Numerical Study of Thin-Walled Polymer Composite Part Quality When Manufactured Using Vacuum Infusion with Various External Pressure Controls

Numerical simulation of the effect of permeability on the hydrodynamics in a parallel-plate coculture flow chamber.

Unsaturated Flow Behavior in Double-Scale Porous Reinforcement for Liquid Composite Molding Processes

A Simple Method for the Measurement of Compaction and Corresponding Transverse Permeability of Composite Prepregs

Research on the Numerical Simulation of Liquid-Infiltration-extrusion Process for Composites Based on the Rigid-Viscoplastic FEM

Evaluation of through-thickness permeability and the capillary effect in vacuum assisted liquid molding process

Numerical Simulation of Edge Effect in Resin Transfer Molding for Plain-weave Fabric

Novel approach for mold filling simulation of the processing of natural fiber reinforced composites by resin transfer molding