Abstract:Almost every project is accompanied by earthworks, very often involving various types of excavation, and the work of people in the excavations. One of the most important tasks in earthworks is to ensure that the walls of the excavation are protected against sliding and that people working in and around the excavation are safe. Very often, in addition to criteria relating to safety and stability of the excavation, economic considerations are also an important criterion. This issue arises as early as the design stage and is related to the choice of construction and materials of which the shoring is to be made in such a way as to be able to withstand the pressure of the soil, ground loads resulting from stored excavated material and the operation of working machinery. Ongoing monitoring of the excavations and their reinforcement is also very important. The paper describes the unique results of experimental field tests, the purpose of which was to analyse the values of deflections of steel support plates of temporary excavation carried out on the object in 1:1 scale. The course of the experiment is presented for excavation support plates with a total depth of 6 m. Direct tests of the deflection arrow were carried out using two techniques, traditionally with a patch, and with laser scanning. Field tests were carried out for the designed situation without backfill load as well as for backfill load of 3.84, 15.36, 26.88 and 38.4 kN·m-2, respectively, for two measurement stages. Stage-I of the study consisted in collecting the results for soil in intact condition, whereas Stage-II collected results for loosened soil. The research experiment was supported by numerical calculations performed using the finite difference method in variational approach. The measured maximum deflections ranged from 14.40 to 16 mm, and the calculated values were 14.95 and 14.99 mm. The comparison of calculation results and tests proved to be very consistent. The analysis of the values of deflections showed that backfill load does not have a significant effect on the deflection of the lower plate, but it does affect the deflection of the first plate up to a depth of 1.2 m. Based on the obtained results, it is recommended to assume the limit (maximum) deflection arrow for support plates of temporary excavations at least as wgr = L/130, where L is the span of the plate. The calculation of deflection values was based on deflection values obtained experimentally and numerically for two steel variants: S235JR and S355JR. The wgr indicator of the maximum deflection arrow proposed by the authors is not stipulated by the industry standards, but it can be very helpful for the designing of excavation reinforcement.

Ensuring the reliability of fastening of plates behind culverts of reclamation systems of the agro-industrial complex

Back-Analyses of Landfill Instability Induced by High Water Level: Case Study of Shenzhen Landfill

Performance analysis of cast-in-place tubular pile composite ground under embankment load

Deformations of upper soil slopes of retaining structures and shores with violated reinforced concrete fastening in riverbed reservoirs in Belarus

Experimental Study Of Correlation Of Dynamic Compaction For Foundation Backfilled With Crushed Stone

Case Study of the Deep-Seated Concrete Slab for Settlement Control at Bridge Approach Embankment

EXPERIENCE IN STRENGTHENING UNDERGROUND PEDESTRIAN CROSSINGS IN WATER-SATURATED CITY SOILS

VIBRODYNAMIC MONITORING OF SOIL AND STRUCTURES IN THE ARRANGEMENT OF SHUNTED FENCE OF THE DITCH IN CONDITIONS OF DENSITY URBAN BUILDING

Research on Characters of Retaining Structures for Deep Foundation Pit Excavation under Unbalanced Heaped Load

Experimental Validation of Deflections of Temporary Excavation Support Plates with the Use of 3D Modelling

ANALYSIS OF TEST RESULTS OF THE ENBANKMENT REINFORCEMENT WITH REINFORCED SOIL-CEMENT PILES

Application of Reinforced Soil Foundations in the Construction of Wooden Bridge Abutments Along Logging Road

RESULTS OF COMPLEX RESEARCH OF SOIL BASES REINFORCED BY SOIL-CEMENT ELEMENTS MANUFACTURED USING DRILLING MIXING METHOD

Full scale tests of various buried flexible structures under failure load

Assessment of the reasons for the loss of stability of the retaining wall and the choice of slope stabilization options, taking into account the use of retaining walls of different rigidity

Development of a laboratory and experimental installation for checking the reliability of a mathematical model and an information and technical method for preventing emergencies at landfills of solid household waste with technological liquidation energy-intensive equipment

Structural approach to assessing the performance of the monitoring system of engineering structures of the cablestayed bridge over the Petrovsky Canal in the construction of the western speed diameter highway in St. Petersburg. Part 1

PERFORMANCE EVALUATION OF USING INJECTION REINFORCEMENT TECHNOLOGY WITH SELF-EXPANDING GROUT OF SOFT SOILS AT THE SUB-BASE OF SHALLOW FOUNDATIONS

EXPERIMENTAL JUSTIFICATION OF THE SOIL BASE MODEL FOR THE CALCULATION OF THE COMBINED RAFT-PILE FOUNDATION

Performance of composite foundations with different load transfer platforms and substratum stiffness over silty clay

Improvement of metrological measurements of bridge crossings at waterworks when studying non-destructive testing methods