Abstract:Vertical axis wind turbines (VAWTs) have been attracting an increasing attention in recent years because of their potential for effectively using wind energy. The tip vortices from the VAWT blades have a negative impact on the power efficiency. Since a winglet has been proved to be effective in decreasing the tip vortex in the aerospace field, this paper numerically studies the aerodynamic effect of appending a winglet on the blade of a VAWT. Based on the theoretical motion pattern of the VAWT blade, this paper simplifies the three-dimensional full-scale rotor simulation to a one-blade oscillating problem in order to reduce the computational cost. The full rotor model simulation is also used in validating the result. The numerical approach has been validated by the experimental data that is available in the open literature. Six parameters are applied in defining the configuration of the winglet. The orthogonal experimental design (OED) approach is adopted in this paper to determine the significance of the design parameters that affect the rotor's power coefficient. The OED results show that the twist angle of the winglet is the most significant factor that affects the winglet's performance. A range analysis of the OED results produces an optimal variable arrangement in the current scope, and the winglet's performance in this variable arrangement is compared with the blade without a winglet. For the single blade study, the comparison result shows that the optimal winglet can decrease the tip vortices and improve the blade's power performance by up to 31% at a tip speed ratio of 2.29. However, for the full VAWT case, the relative enhancement in the power coefficient is about 10.5, 6.7, and 10.0% for TSRs of 1.85, 2.29, and 2.52, respectively. The winglet assists in maintain the pressure difference between the two sides of the blade, thus weakening the tip vortex and improving the aerodynamic efficiency of the surface near the blade tip.

Aerodynamic performance of semi-wing with multiple winglets operating at low- and medium-range Reynolds numbers

Bioinspired wingtip devices: a pathway to improve aerodynamic performance during low Reynolds number flight

Experimental investigation on tip-vortex flow characteristics of novel bionic multi-tip winglet configurations

Numerical simulation on aerodynamic performance of bird-like flapping wing with slotted-tip

Enhancing Lift and Reducing Wingtip Vortices Using a Passive Rotor on Finite-Span Wings

Optimizing Winglet Cant Angle for Enhanced Aircraft Wing Performance Using CFD Simulation and Hybrid ANN‐GA

Study the Effect of Winglet Height Length on the Aerodynamic Performance of Horizontal Axis Wind Turbines Using Computational Investigation

Wing Efficiency Enhancement at Low Reynolds Number

Numerical study of the aerodynamic effects of bio-inspired leading-edge serrations on a heaving wing at a low Reynolds number

Wing Optimisation for a tractor propeller driven Micro Aerial Vehicle

The investigation of different wing-lets impact on Wing tip vortex

High-resolution numerical investigation into the effects of winglet on the aerodynamic performance for a three-dimensional vertical axis wind turbine

Winglet Design for Vertical Axis Wind Turbines Based on a Design of Experiment and CFD Approach

A numerical study of bio-inspired wingtip modifications of modern wind turbines

CFD-based study of several geometrical parameters of winglet

The effect of using winglets to enhance the performance of swept blades of a horizontal axis wind turbine

A CFD Analysis of Wingtip Devices to Improve Lift and Drag Characteristics of Aircraft Wing

Geometry optimization studies on nonplanar wingtip devices for typical transport aircraft

Commercial Aircraft Performance Improvement Using Winglets

Aerodynamic design of low-Reynolds-number wing taking into account the multiple propellers induced effects

Aerodynamic shape optimization at low Reynolds number using multi-level hierarchical Kriging models