Abstract:This paper describes an investigation of the possible benefits from wing optimisation in improving the performance of Micro Air Vehicles (MAVs). As an example we study the Avion (3.64 kg mass, 1.60 m span), being designed at the CSIR National Aerospace Laboratories (NAL), Bengaluru. The optimisation is first carried out using the methodology described by Rakshith \emph{et al.} (using an in\textendash house software PROWING), developed for large transport aircraft, with certain modifications to adapt the code to the special features of the MAV. The chief among such features is the use of low Reynolds number aerofoils with significantly different aerodynamic characteristics on a small MAV. These characteristics are taken from test data when available, and/or estimated by the XFOIL code of Drela. A total of 8 optimisation cases are studied for the purpose, leading to 6 different options for new wing planforms (and associated twist distributions along the wing span) with an improved performance. It is found that the improvements in drag coefficient using the PROWING code are about 5%. However, by allowing the operating lift coefficient $C_L$ to float within a specified range, drag bucket characteristics of the Eppler E423 aerofoil used on Avion can be exploited to improve the endurance, which is a major performance parameter for Avion. Thus, compared to the control wing $W_0$ (with operating point at $C_L$ =0.7) used in the preliminary design, permitting a variation of $C_L$ over a range of $\pm$ 10% is shown to enhance the endurance of wing $W_4$ by 18.6%, and of wing $W_{6}$ with a permitted $C_L$ range of $\pm$ 50% by 39.2%. Apart from the philosophy of seeking optimal operating conditions for a given configuration, the advantages of optimising design parameters such as washout of a simple wing proposed in the preliminary design stage, is also demonstrated.

Commercial Aircraft Performance Improvement Using Winglets

Design optimization of a morphing winglet for all flight missions of a civil aircraft

Optimum Induced Drag of Wingtip Devices: The Concept of Best Winglet Design

A CFD Analysis of Wingtip Devices to Improve Lift and Drag Characteristics of Aircraft Wing

Aerodynamic performance of semi-wing with multiple winglets operating at low- and medium-range Reynolds numbers

Optimizing Winglet Cant Angle for Enhanced Aircraft Wing Performance Using CFD Simulation and Hybrid ANN‐GA

A Robust Design for a Winglet Based on NURBS-FFD Method and PSO Algorithm

Computational Investigations for the Feasibility of Passive Flow Control Devices for Enhanced Aerodynamics of Small-Scale UAVs

Drag Reduction by Wingtip-Mounted Propellers in Distributed Propulsion Configurations

Aerodynamic Design and Strength Analysis of the Wing for the Purpose of Assessing the Influence of the Bell-Shaped Lift Distribution

Real-time optimization of wing drag and lift performance using a movable leading edge

Wing Optimisation for a tractor propeller driven Micro Aerial Vehicle

Wing Optimization of Propeller Aircraft Based on Actuator Disc Method

Analytical and Experimental Studies on Modified Wing Configurations of Cessna 172-R Aircraft to Improve Performance

New Aerodynamic Studies of an Adaptive Winglet Application on the Regional Jet CRJ700

Enhancing Lift and Reducing Wingtip Vortices Using a Passive Rotor on Finite-Span Wings

Review on the Structure Design of Morphing Winglets

Geometry optimization studies on nonplanar wingtip devices for typical transport aircraft

THE EFFECTS OF ANGLE OF ATTACK, REYNOLD NUMBERS AND WINGLET STRUCTURE ON THE PERFORMANCE OF CESSNA 172 SKYHAWK

The Optimal Design of Civil Aircraft Winglet with Multiple Constraint

Optimization Efficiency of the Aircraft Wing of Cessna 172 Skyhawk by Absorbent Adverse Pressure Using Tangential Suction Slot Without Vacuum Device