Abstract:The setting time of the paste and the rheological properties and microstructure of the mortar after replacing OPC cement with silica fume (SF), fly ash cenosphere (FAC) and nano-silica are studied as a reference for shotcrete applications. The suggested contents of SF, FAC and nano-silica are around 5–7.5%, higher than 20% and 1–3%, respectively, to meet the initial setting time specification. Viscosity and yield stress of mortar are highly dependent on water/cement ratio and paste/sand ratio. At the higher water/cement ratio, viscosity is more based on the paste itself. For SF of 2.5–10%, viscosity and yield stress increase, and the flowability of the mixture decreases. For FAC of 5–25%, viscosity and yield stress increase with a lower rate than SF, and flowability increases at 5% and then decreases as FAC content increases, which, however, is at the same level as the control. When SF and FAC are both added, a tortuous behavior of viscosity is shown. As nano-silica is further added, significant increases in viscosity and yield stress are shown. The compressive strengths of mortar with different supplementary cementitious materials (SCMs) at early ages are close. The difference in compressive strength after 28 days of standard curing is significant. The SF5-FAC15 group exhibits the largest increase in strength for 32.82%. At the age of 2.5 h, the macropore areas distribution of SF5-FAC25-NS1.5 test groups were 31.96%, indicating the lowest macropore area distribution. The secondary hydration reaction of supplementary cementitious materials (SCMs) continuously generates products that fill the pores, and the ultrafine filling effect of nanomaterials improves the compactness of the mortar microstructure and reduces the macropore area distribution. The mercury intrusion test results of the SF5-FAC25-NS1.5 group show that the pores are concentrated within the range of 0.01 to 0.05 μm, and the most probable pore size is significantly smaller than that of the CTR group. As the overall replacement level of SCMs increases, the diffraction peak of calcium hydroxide gradually weakens.

Microstructural analysis of aerated cement pastes with fly ash, Metakaolin and Sepiolite additions

Rheological properties of aerated cement pastes with fly ash, metakaolin and sepiolite additions

Thermal analysis and microstructure of Portland cement-fly ash-silica fume pastes

Properties of Mortars Formulated from Self-Compacting High-Performance Concrete Containing Various Mineral Additions

A Study on the Microstructure and Mechanical Properties of Portland Cement Incorporating Aluminosilicate Waste

Characterization of morphology and hydration products of high-volume fly ash paste by monochromatic scanning x-ray micro-diffraction (μ-SXRD)

Rheology and alkali-silica reaction of alkali-activated slag mortars modified by fly ash microsphere: a comparative analysis to OPC mortars

Effect of Fly Ash and Metakaolin on Properties and Microstructure of Magnesium Oxysulfate Cement

Effects of packing density and water film thickness on fresh and hardened properties of ternary cement pastes

Microstructure Evolution Mechanism of Quaternary Phase Paste Containing Metakaolin and Silica Fume

Influence of metakaolin on the hydration and microstructure evolution of cement paste during the early stage

Mechanical properties and micro-structure analysis of concrete adding high performance composite cementious material

Mix and measure II: joint high-energy laboratory powder diffraction and microtomography for cement hydration studies

Inventive Microstructural and Durability Investigation of Cementitious Composites Involving Crystalline Waterproofing Admixtures and Portland Limestone Cement

A Study of the Influence of Cement Addition and Humidity on the Mechanical Strength and Microstructure of Flue Gas Desulfurization Gypsum–Cement Plasters

Rheological Behavior and Microstructure Characteristics of SCC Incorporating Metakaolin and Silica Fume

Evaluating Durability: A Comparative Study on the Influence of Fly Ash and Silica Fume in Potassium Magnesium Phosphate Cement Mortar

Rheological behaviour, setting time, compressive strength and microstructure of mortar incorporating supplementary cementitious materials and nano-silica

Pore structure characterization of cement pastes blended with high-volume fly-ash

Effects of fly ash, phosphoric acid, and nano-silica on the properties of magnesium oxychloride cement

Approaches to enhance the carbonation resistance of fly ash and slag based alkali-activated mortar- experimental evaluations