Abstract:The modification of eutectic silicon plays a crucial role in enhancing the mechanical properties of hypoeutectic Al-Si alloys. However, there is still limited understanding regarding the factors that affect the modification of eutectic silicon in hypoeutectic Al-Si alloys, particularly in terms of the role played by alloying elements during the modification process. In order to address this gap, this study aimed to investigate the influence of two key alloying elements, Mg and Cu, on the modification effect of Sr. To achieve this, the morphology of eutectic silicon in the as-cast and heat-treated states of Al-7Si alloy, modified with Sr, was examined using scanning electron microscopy (SEM). Different levels of magnesium and copper content were used to analyze their impact on the modification effect of Sr. The results obtained from the analysis revealed that both Mg and Cu significantly weaken the modification effect of strontium on eutectic silicon. Furthermore, it was observed that the degree of deterioration in the modification effect increases progressively with higher alloying element content. Interestingly, increasing the strontium content and adjusting the cooling rate were found to be ineffective in eliminating this weakening effect caused by Mg and Cu. These findings highlight the complex interplay between alloying elements and the modification process of eutectic silicon in hypoeutectic Al-Si alloys. A deeper understanding of these factors is essential for the development of effective strategies to optimize the mechanical properties of such alloys.

Factors affecting eutectic Si modification in Al-Si hypoeutectic alloy with the addition of Na, Sr, Eu and Yb

Effect of Alloying Elements Mg and Cu on the Modification of Eutectic Silicon in Hypoeutectic Al-Si Alloys

Influence of Alloying Element Mg on Na and Sr Modifying Al-7Si Hypoeutectic Alloy

Modification mechanism and tensile property of Al-9Si-0.4Mg-0.1Cu alloy

INFLUENCE OF ADDITIVE Sr OR Sb ON MODIFICATION OF Al-Si ALLOYS

Effects of Sr Modification on Microstructure of Al-Si Alloy

Super-gravity field assisted homogeneous distribution of sub-micron eutectic Si in Al-Si alloy

Effect of Sr modification on microstructure and thermal conductivity of hypoeutectic Al−Si alloys

The Effect of Solution Treatment on the Si Particles’ Morphology Evolution and the Thermal Conductivity and Tensile Properties of Sb-Modified Al-8Si-0.6Mg Alloys

Effect of Sr Modification on the Microstructures, Mechanical Properties, and Thermal Conductivity of Hypoeutectic Al-13.6Cu-6Si Alloys

Effects of Refinement and Modification on Melt Structure of Hypoeutectic Al-Si Alloy

Modification of Eutectic Si in Al–Si Alloys with Eu Addition

Synergistic Effect of Strontium and Melt Quenching on the Solidification Microstructure of Hypereutectic Al-Si Alloys

Growth Mechanism of Eutectic Si in Super-Gravity Solidified Al-Si Alloy During Annealing

Effect of Yttrium Addition on Microstructure and Mechanical Properties of Sr-Modified Low-Si Cast Aluminum Alloy

Distributions of Sr and Fe and Their Influence on Modification of Hypoeutectic Al-Si Alloy

Effect of Modification with Different Contents of Sb and Sr on the Thermal Conductivity of Hypoeutectic Al-Si Alloy

Microstructure Evolution and Modification Mechanism of the Ytterbium Modified Al–7.5%Si–0.45%Mg Alloys

Study on the Eutectic Modification Level of Al–7Si Alloy by Computer Aided Recognition of Thermal Analysis Cooling Curves

Effect of strontium and melt purification on the solidification microstructure of hypereutectic Al-Si alloys

Combined Treatment of Sr and B and Evaluation of Refinment-Modification Levels for Al-7si Casting Alloy