Abstract:Vortex generator (VG) is a passive flow control technology, which can effectively inhibit flow separation. Recently, significant research efforts have been devoted to the study on the application of VG in airfoil, wing/blade and aircraft flow separation inhibition. However, the research on the variable height distribution of VG along the wingspan still lacks. This study focuses on the experimental investigation of the influence of variable height distribution of ramp VG on aerodynamic characteristics. First, VG was designed, such that it was composed of two parts, one fixed region and one deformed region, which allowed for height modification. The height of VGs along the wingspan presented equal-height, triangular and trapezoidal distribution, forming a total of 15 VG layouts. Then, the connection mode of the model, the change of angle of attack and the collection and processing of aerodynamic data were introduced. Finally, a wind tunnel experiment was performed to investigate the influence of height distribution of VG on aerodynamic characteristics of wing. The experimental results show that: (1) the height distribution of the three types of VGs could inhibit the stall flow and improve the aerodynamic performance of the wing; (2) "Triangular translation 3" and "Trapezoidal translation 2" were the best layouts, both of which could increase the maximum lift coefficient, delay stall, and significantly increase the lift-to-drag ratio at high angle of attack; (3) the influence of VG height and position factors on wing stall characteristics was analyzed by using the rough set theory, and the key position information of VG arrangement was provided. This study indicates that the variable height distribution is obviously better than the equal height distribution, which can provide ideas and references for the active control of variable height distribution of VGs.

Study on vortex generator on automobile and airplane

Study On Vortex Generators For Control Of Attached Cavitation

Research on the Effect of Vortex Generators on Controlling Flow Separation of Hydrofoil

Parametric optimization of vortex generator configuration for flow control in an intake duct for waterjet propulsion

Vortex generators project for an unmanned small airplane

Computational Studies of Passive Vortex Generators for Flow Control on High-Speed Train

Effect of Vortex Generations on Aerodynamic Performance of Rough Wind Turbine Airfoil

Efficient Design Method for Applying Vortex Generators in Turbomachinery

Hydrodynamic flow separation control through vortex generators

Study Development of Applying Vortex Generator Jet to Flow Control in Fluid Machinery

Flow control on the NREL S809 wind turbine airfoil using vortex generators

Vortex Generator Evaluation Models and Flow Mechanisms for Compressor Cascade

Investigation on the influence of vortex generator on particle resuspension

Effect of vortex generator spanwise height distribution pattern on aerodynamic characteristics of a straight wing

Lessons Learnt from the Simulations of Aero-Engine Ground Vortex

Study of Control Effects of Vortex Generators on a Supercritical Wing

Numerical study on improving the hydrodynamic performance of three-dimensional unsteady hydrofoil through vortex generators

Experimental and Numerical Investigation of a Novel Vortex Reducer in a Co-Rotating Cavity of Aeroengines

Vacuum and Energy Separation Characteristics of Tornado-Like Vortices

Simulation of Aerodynamic Performance Affected by Vortex Generators on Blunt Trailing-Edge Airfoils

Aerodynamic simulations of an electric vertical takeoff and landing aircraft using reformulated vortex particle method