Abstract:Abstract Reinforced concrete bridges are iconic parts of modern infrastructure. They are designed for a minimum service life of 100 years. However, environmental factors and/or inappropriate use might cause overload and accelerate the deterioration of bridges. In extreme cases, bridges could collapse when necessary maintenance lacks. Thus, the permanent monitoring for structure health assessment has been proposed, which is the aim of structural health monitoring (SHM). Studies in laboratories have shown that ultrasonic (US) coda wave interferometry (CWI) using diffuse waves has high sensitivity and reliability to detect subtle changes in concrete structures. The creation of micro-cracks might be recognized at an early stage. Moreover, large-volume structures can be monitored with a relatively small number of US transducers. However, it is still a challenge to implement the CWI method in real SHM practical applications in an outdoor environment because of the complex external factors, such as various noise sources that interfere with the recorded signals. In this paper, monitoring data from a 36-m long bridge girder in Gliwice, Poland, instrumented with embedded US transducers, thermistors, and vibrating wire strain gauges, is presented. Noise estimation and reduction methods are discussed, and the influence of traffic, as well as temperature variation, are studied. As a result, the relative velocity variation of US waves following the temperature change with a very high precision of $$10^{-4} \%$$ 10 - 4 % is shown, and a good bridge health condition is inferred. The influence of lightweight real traffic is negligible. The study verified the feasibility of the implementation of the CWI method on real bridge structures.

A study of measurements and countermeasures for low-frequency noise caused by expressway bridges

Study on low-frequency noise radiated from steel multi-box girder bridge induced by traffic vibration

A Numerical Method for Analyzing the Low-Frequency Noise of Bridge under Vehicle Load

Dynamic Monitoring and Data Analysis of a Long-Span Arch Bridge Based on High-Rate GNSS-RTK Measurement Combining CF-CEEMD Method

Assessment of Sound Pressure of Transient Noise Radiated from Vehicle-Bridge Coupling Vibration

Theoretical analysis of low-frequency noise radiated from bridge vibrations

Analysis on Low-Frequency Noise Induced by Vehicle-Bridge Coupling Vibration

Assessment on Transient Sound Radiation of a Vibrating Steel Bridge Due to Traffic Loading

Low-frequency noise radiation from traffic-induced vibration of steel double-box girder bridge

Measurement and analysis of bridge expansion joint noise

Estimating Bridge Natural Frequencies Based on Modal Analysis of Vehicle–Bridge Synchronized Vibration Data

Reducing low-frequency noise radiation from a concrete box girder bridge using acoustic short circuits

Investigating noise radiation pattern of railway bridges for urban rail transit

Remote Bridge Monitoring Using Infrasound

Influence of the Acoustic Cover of the Modular Expansion Joint on the Acoustic Climate in the Bridge Structure Surroundings

Automated mobile vibration measurement and signal analysis for bridge scour prevention and warning

Noise Reduction for Improvement of Ultrasonic Monitoring Using Coda Wave Interferometry on a Real Bridge

Investigation of ambient noise seismological methods on a bridge model

Tuned Mass Dampers for Wind-Induced Vibration Control of Chongqi Bridge

Newly Constructed Subway on Over-Track Bridge Safety and Vibration Reduction Measure

Wind Tunnel Study on Aerodynamic Characteristics of the Train on Viaducts with a New Type of Wind–Noise Barrier Under Cross Wind