Estimating Bridge Natural Frequencies Based on Modal Analysis of Vehicle–Bridge Synchronized Vibration Data

Eugene Mudahemuka,Masatatsu Miyagi,Ryota Shin,Naoki Kaneko,Yukihiko Okada,Kyosuke Yamamoto

DOI: https://doi.org/10.3390/s24041060

IF: 3.9

2024-02-07

Sensors

Abstract:This paper presents a method for accurately estimating the natural frequencies of bridges by simultaneously measuring the acceleration vibration data of vehicles and bridges and applying modal analysis theory. Vibration sensors synchronized with GPS timing were installed on both vehicles and bridges, achieving stable and high-precision time synchronization. This enabled the computation of the bridge's Frequency Response Functions (FRFs) for each mode, leading to a refined estimation of natural frequencies. The validity of the theory was confirmed through numerical simulations and experimental tests. The simulations confirmed its effectiveness, and similar trends were observed in actual bridge measurements. Consequently, this method significantly enhances the feasibility of bridge health monitoring systems. The proposed method is suitable for road bridges with spans ranging from short- to medium-span length, where the vehicle is capable of exciting the bridge.

engineering, electrical & electronic,chemistry, analytical,instruments & instrumentation

What problem does this paper attempt to address?

The problem that this paper attempts to solve is how to estimate the natural frequencies of bridges, especially the high - order modal frequencies, more accurately in bridge health monitoring systems. Traditional vibration monitoring methods have limitations when detecting local damage to bridges, because the low - order modes are less sensitive to local damage, and although the high - order modes are more sensitive to local damage, their observation and accurate estimation are more difficult. In addition, environmental factors such as temperature changes and noise can also affect the estimation accuracy of the natural frequencies of bridges.

To solve these problems, the paper proposes a modal analysis method based on vehicle - bridge synchronous vibration data. By installing time - synchronized acceleration sensors on the vehicle and the bridge and using GPS for time synchronization, the vibration data of the vehicle and the bridge can be measured simultaneously. This method can calculate the frequency response function (FRF) of the bridge, thereby estimating the natural frequencies of the bridge, especially the high - order modal frequencies, more accurately. The paper verifies the effectiveness of this method through numerical simulation and field experiments on actual bridges, and proves its potential application value in bridge health monitoring.