Abstract:S urface a coustic w ave (SAW) devices are subject to thermomechanical coupling during operation, and when the temperature rises sharply to 180 °C, the surface of the lithium niobate crystal substrate generates nonuniform thermal stresses, thus leaving large residual stresses after complete cooling, which seriously influences its service performance and life. In this study, the thermal residual stresses of lithium niobate wafers were tested by nanoindentation tests, and the nanoindentation test process was simulated. The inverse calculation of the parameters of the lithium niobate constitutive model was carried out by comparing the load-displacement curves obtained from the finite element calculations with the experimental results. A multiscale model of the SAW device was established, its operation process was simulated, and then the generation law of residual stress was further discussed. The nanoindentation test results show that the thermal residual stress is positively correlated with the heating time under the effect of the same temperature; however, at the heating temperature up to about 180 °C, the lithium niobate crystal enters the high-temperature hyperelastic interval, and the yield stress of the crystal increases significantly at this stage. The constitutive model curves obtained by finite element calculations are in good agreement with the experimental results, and the thermal residual stress value of lithium niobate can reach 2/3 of its yield stress outside the high-temperature hyperelastic interval by comparison tests. The calculation results of the multi-scale model of the SAW device indicate that excessive thermal stress is the main cause of damage during the thermo-mechanical coupling of the SAW device. The polarization direction of lithium niobate crystals may cause the development of damage cracks, increasing the heat dissipation can effectively reduce the thermal stress to which it is subjected, and better extend the service life of the SAW device.

Acoustically driven spin wave resonance in Ni/128° Y-cut LiNbO3 hybrid devices with the beam steering effect

Nonreciprocal magnetoacoustic waves with out-of-plane phononic angular momenta

A Simulated Investigation of Lithium Niobate Orientation Effects on Standing Acoustic Waves

On‐Chip Tightly Confined Guiding and Splitting of Surface Acoustic Waves Using Line Defects in Phononic Crystals

Investigation on effects of thermo-mechanical coupling on residual stress in lithium niobate in surface acoustic wave device

High speed surface acoustic wave and laterally excited bulk wave resonator based on single-crystal non-polar AlN film

Surface Acoustic Wave Characteristics Based on C-Axis (006) LiNbO3/diamond/silicon Layered Structure

Coherent surface acoustic wave–spin wave interactions detected by micro-focused Brillouin light scattering spectroscopy

Symmetry and nonlinearity of spin wave resonance excited by focused surface acoustic waves

Giant nonreciprocity of surface acoustic waves induced by an anti-magnetostrictive bilayer

Design and Analysis of Lithium-Niobate-Based Laterally Excited Bulk Acoustic Wave Resonator with Pentagon Spiral Electrodes.

Surface Modification and Coherence in Lithium Niobate SAW Resonators

Interaction of acoustic waves with spin waves using a GHz operating GaN/Si SAW device with a Ni/NiFeSi layer between its IDTs

Monolithic Strong Coupling of Topological Surface Acoustic Wave Resonators on Lithium Niobate

Pseudospin Modes of Surface Acoustic Wave and Topologically Protected Sound Transmission in Phononic Crystal

Large nonreciprocity of shear-horizontal surface acoustic waves induced by a magnetoelastic bilayer

Surface Acoustic Wave Induced Streaming and Pumping in 128° Y-cut LiNbO3for Microfluidic Applications

High acoustic velocity x -cut lithium niobate sub-terahertz electromechanics

Spin wave generation by surface acoustic waves

Giant Nonreciprocity of Surface Acoustic Waves induced by a positive-negative magnetostrictive heterostructure

Large Nonreciprocity of Shear-Horizontal Surface Acoustic Waves induced by Magnetoelastic Bilayers