Abstract:Laser powder bed fusion (LPBF) is an additive manufacturing (AM) process in which a high power laser melts metal powder layers into complex, three-dimensional shapes. LPBF parts are known to exhibit relatively high residual stresses, anisotropic microstructure, and a variety of defects. To mitigate these issues, in-situ measurements of the melt-pool phenomena may illustrate relationships between part quality and process signatures. However, phenomena such as spatter, plume formation, laser modulation, and melt-pool oscillations may require data acquisition rates exceeding 10 kHz. This hinders use of relatively data-intensive, streaming imaging sensors in a real-time monitoring and feedback control system. Single-point sensors such as photodiodes provide the temporal bandwidth to capture process signatures, while providing little spatial information. This paper presents results from experiments conducted on a commercial LPBF machine which incorporated synchronized, in-situ acquisition of a thermal camera, high-speed visible camera, photodiode, and laser modulation signal during fabrication of a nickel alloy 625 AM part with an overhang geometry. Data from the thermal camera provides temperature information, the visible camera provides observation of spatter, and the photodiode signal provides high temporal bandwidth relative brightness stemming from the melt pool region. In addition, joint-time frequency analysis (JTFA) was performed on the photodiode signal. JTFA results indicate what digital filtering and signal processing are required to highlight particular signatures. Image fusion of the synchronized data obtained over multiple build layers allows visual comparison between the photodiode signal and relating phenomena observed in the imaging detectors.

On the potential of ultrasonic time of flight instrumentation for the monitoring of thermal phenomena in laser powder bed fusion

Single-camera Two-Wavelength Imaging Pyrometry for Melt Pool Temperature Measurement and Monitoring in Laser Powder Bed Fusion based Additive Manufacturing

Thermal Based Process Monitoring for Laser Powder Bed Fusion (LPBF)

Transient Dynamics of Powder Spattering in Laser Powder Bed Fusion Additive Manufacturing Process Revealed by In-Situ High-Speed High-Energy X-Ray Imaging

Direct mechanistic connection between acoustic signals and melt pool morphology during laser powder bed fusion

Broadband infrared confocal imaging for applications in additive manufacturing

Using Laser Ultrasound to Detect Subsurface Defects in Metal Laser Powder Bed Fusion Components

Development of instrumentation for eddy current in situ monitoring of laser powder bed fusion

Real-time monitoring of laser powder bed fusion process using high-speed X-ray imaging and diffraction

In Situ Characterization of Laser-Generated Melt Pools Using Synchronized Ultrasound and High-Speed X-ray Imaging.

Multiple Sensor Detection of Process Phenomena in Laser Powder Bed Fusion

Metal Laser-Based Powder Bed Fusion Process Development Using Optical Tomography

Laser-metal interaction dynamics during additive manufacturing resolved by detection of thermally-induced electron emission

Development of laser ultrasonics inspection for online monitoring of additive manufacturing

Spatiotemporal characterization of evaporated atoms during electron beam melting additive manufacturing by advanced laser diagnostics

Ultrafast X-ray Imaging of Laser–metal Additive Manufacturing Processes

Energy Coupling Mechanisms and Scaling Behavior Associated with Laser Powder Bed Fusion Additive Manufacturing

Dynamics of pore formation during laser powder bed fusion additive manufacturing

Harmonizing sound and light: X-ray imaging unveils acoustic signatures of stochastic inter-regime instabilities during laser melting

Numerical and experimental investigation of the geometry dependent layer-wise evolution of temperature during laser powder bed fusion of Ti–6Al–4V

Application of active thermography for the study of losses in components produced by laser powder Bed fusion