Abstract:In this paper, quenched AerMet100 steel specimens are plasma nitrided at different temperatures (from 440 °C to 500 °C), and their microstructures and mechanical properties are investigated. Surface layer hardness variation induced by plasma nitriding is also analyzed and correlated with microstructural characteristics and concentration distributions of carbon and nitrogen. Results show that wear resistance of AerMet100 steel after nitriding treatment exhibits various degrees of improvement compared with the un-treated specimen. Especially for the nitrided specimens from 460 °C to 500 °C, volume wear rate is reduced by more than 88%. Such great improvement is mainly attributed to the absence of brittle ε-Fe2-3N phase and the presence of a thick gradient nitrided layer. The interfacial properties of γ′-Fe4N(111)/α′N(011) are investigated by first-principles calculations. Six interface models with different γ′-Fe4N(111) termination and stacking sites are investigated to clarify their effects on the interfacial adhesion. The Fe-terminated Bridge site model exhibits a stronger adhesion tendency after relaxation, which can be regarded as the strongest interface. We found that the alloying additives benefit the γ′-(Fe,M)4N(111)Fe/α′N(011) interfacial adhesion in the order Si < Zr < Cu < Al < Ni < Mn < Co < Nb < Ti < V < Mo < Fe < Cr. Wherein, only Cr can be regarded as enhancers, and doping with Cr and Si are the most prominent representatives of strengthening and weakening effects, respectively. In addition, the bonding characteristics of two representative interface structures doped with Cr and Si are further studied. Density of states (DOS) and crystal orbital Hamilton population (COHP) analysis indicate that the significantly improved interfacial adhesion of Cr-doped is mainly due to the significant improvement of the enhanced Fe-Fe bonding. These results may provide some important inspirations for future experimental work of preparing high-performance nitrided layer.

Effects of N doping on mechanical properties of Fe and interlayer adhesion of Fe with Cr, Ti, and Si: A spin-polarized density functional theory study

Site preference of S-doping and its influence on the properties of a Ni/Ni3Al interface

First-principle Study of Interfacial Properties of Ni–Ni3Si Composite

Effect of Nb-doping on the Structure, Magnetic, and Mechanical Properties for Fe–N Films Synthesized by Facing-Targets Magnetron Sputtering

Potential Mechanisms of Interstitial Atomic Enhancement and Interface Failure Behavior in Ni3Co/Cu Systems

Effects of Ti Doping on the Structures and Magnetic Properties of Films

Effects of Ti Interlayer on Adhesion Property of DLC Films: A First Principle Study

Potential Mechanisms of Interstitial Atomic Enhancement and Interface Failure Behavior in Ni 3 Co/Cu Systems

Microscopic mechanism of the effect of Nb and Cr co-doping on the strength and ductility of Ti2AlC/Ti3Al coherent interface

First-principles Study on the Effects of N and Al Doping on the Mechanical Properties and Electronic Structures of TiC

Ab Initio Study of Energetics, Charge Transfer, and Atomic Structures of FCC Fe/NbC Interfaces with and Without N Doping: from Coherent to Semi-coherent Interfaces

The Effect of Impurities on the Adhesion Behavior of TiN(1 1 1)/Α-Ti(0 0 0 1) Semi-Coherent Interface: A First-Principles Investigation

The Effects of Ti/Ni Doping on the Friction and Wear Properties of DLC Coatings

Atomic-structure and Charge Redistribution Modified by Intrinsic Strain in Α-Fe/tmn (tm=ti/zr/hf/v/nb/ta) Interfaces

Nitriding Behavior and Mechanical Properties of AerMet100 Steel and First-Principles Calculations of Phase Interfaces

Study on the Structure, Morphology and Properties of Fe-Doped Cu3n Films

Combined Effects of Carbon and Nitrogen in Fe20Cr6Mn6CN Alloys from First-Principles Calculation

Effect of Nitrogen Doping on Surface Morphology, Microstructure, Chemical Composition and Intrinsic Stress of Nickel Thin Films Deposited by Reactive Sputtering

The Effect of Fe Doping on the Crystallization Kinetics of Ni-Mn-Sn Free-Standing Alloy Thin Films

The Fe-N system: crystal structure prediction, phase stability, and mechanical properties

Effect of Cr Doping on the Surface Characteristics of Ni Metal Studied with First-Principles Calculation