Abstract:Agricultural wastes are potential sustainable adsorbents since they are available in large quantities, are low-cost, and may require little or no treatment, in some cases. In this study, several fruit peels, such as banana, orange, and pomegranate, were collected from local markets and prepared by a simple and eco-friendly method and used as natural adsorbents for the removal of both anionic (Reactive Red 120 (RR120), Reactive Black 5 (RB5), Remazol Brilliant Blue R (RBBR)) and cationic Methylene Blue (MB) dyes found in wastewaters. Many industries, such as leather and textiles, can release huge amounts of synthetic dyes into the wastewater during dyeing processes. These are one of the most important pollutants of water pollution as they cause enormous damage to the water body and also affect the health of organisms due to their toxicity and carcinogenicity. The search for a sustainable and at the same time efficient material for the removal of a wide variety of dyes is the innovation of this work. These peels were prepared by washing, drying, grinding, and finally sieving, under natural sustainable conditions. Porosometry (BET analysis), FTIR, SEM/EDS, and XRD techniques were used to characterize the fruit peels before and after the adsorption process. Factors affecting the adsorption of dyes (adsorbent dosage, pH solution, initial concentration of dyes, contact time, and temperature) were investigated. According to the results, in terms of the effectiveness of fruit peels as (natural) adsorbent materials, for anionic dyes, 5.0–6.0 g/L of banana or orange dry peels was sufficient to remove near or even more than 90% anionic dyes at pH 2.0, and 4.0 g/L was sufficient to remove 98% of cationic MB dye at pH 9.0. Similar amount of pomegranate peels had lower efficiency for anionic dyes (50–70%), while cationic MB was still efficiently removed (98%) at pH 9.0. Moreover, the adsorption process in all cases was found to better fit to pseudo-second-order model, in comparison to pseudo-first-order model. According to isotherms, Freundlich model fitted better in some cases to the equilibrium data, while the Langmuir model in others. Finally, this study demonstrates the viability of reusing the banana, orange, and pomegranate peel adsorbents for eight, four, and five cycles, showing a gradual reduction of around 50% of their effectiveness.

Use of the Box–Behnken Experimental Design for the Optimization of Orange II (Acid Orange 7) Adsorption on Aloe vera

Assessment of potato surpluses as eco-friendly adsorbent for removal of Orange II: optimization and kinetic modelling at different pH values

Modeling and optimizing Orange G removal by heat-activation persulfate using two-step statistical strategies: Plackett-Burman and Box-Behnken designs

Experimental and Theoretical Insights on Methylene Blue Removal from Wastewater Using an Adsorbent Obtained from the Residues of the Orange Industry

Bio-Waste Aloe vera Leaves as an Efficient Adsorbent for Titan Yellow from Wastewater: Structuring of a Novel Adsorbent Using Plackett-Burman Factorial Design

Optimized removal of methylene blue using chemically activated and thermally modified Opuntia ficus-indica bioadsorbent: a response surface methodology approach

Basic-dye adsorption in albedo residue: Effect of pH, contact time, temperature, dye concentration, biomass dosage, rotation and ionic strength

Removal of Azo Dyes Orange II and Reactive Black 5 from Aqueous Solutions by Adsorption on Chitosan Beads Modified with Choline Chloride: Urea Deep Eutectic Solvent and FeO

Polymeric Matrix of Modified Chitosan with Algae and Coal Fly Ash for a Toxic Cationic Dye Removal: Multivariable Optimization by Box-Behnken Design

Acridine Orange and Its Removal from Aqueous Solutions by Adsorption

Adsorbent Biomaterials Based on Natural Clays and Orange Peel Waste for the Removal of Anionic Dyes from Water

An Eco-friendly Adsorbent of Chitosan/Montmorillonite/Algae for Removal of Basic Green 1 and Reactive Blue 19 Dyes: Box-Behnken Design Optimization Mechanistic Study

Application of Box–Behnken factorial design for parameters optimization of basic dye removal using nano-hematite photo-Fenton tool

Simultaneous removal of anionic and cationic dyes on quaternary mixtures by adsorption onto banana, orange and pomegranate peels

Sustainable use of low-cost adsorbents prepared from waste fruit peels for the removal of selected reactive and basic dyes found in wastewaters

A Novel Sponge Composite of Chitosan-Sodium Tripolyphosphate-Melamine for Anionic Dye Orange II Removal

Development of a novel bionanocomposite of UiO-66/xanthan gum/alginate crosslinked by calcium chloride for azo dye removal: Insight into adsorption kinetics, isotherms, and thermodynamics

High Performance Adsorption of Orange II Dye Onto Modified Mussel Shell Powder

Zwitterion Adsorbent of Crosslinked Chitosan-Benzil/Algae/Coal Fly Ash for Anionic (Remazol Brilliant Blue R) and Cationic (Thionine) Dyes Removal: Box–Behnken Design Optimization

Adsorption of lead(II) from aqueous solution using Africa elemi seed, mucuna shell and oyster shell as adsorbents and optimization using Box–Behnken design

Kinetic and thermodynamic analysis of alizarin Red S biosorption by Alhagi maurorum: a sustainable approach for water treatment