Abstract:Molten-Salt Reactors (MSRs) use molten-salt fluid-fuel, which contains thorium (Th) and uranium-233 (233U) as fertile and fissile, respectively. Also, the MSRs can accept plutonium (Pu) as fissile. Besides the above benefit on nuclear fuel cycle, the MSR has other many advantages such as the power-size flexibility, no necessity of refueling, effective incineration of minor actinides (MA), excellent safety, and good economy. The cycle produces very small amount of MA compared with the conventional U fuel cycle. Also, 233U accompanies high gamma-ray emissions, and this fact contributes to the resistance to nuclear proliferation issues. The MSRs has been studied since early 1950's in Oak Ridge National Laboratory (ORNL), and the Molten-Salt test Reactor Experiment (MSRE) has shown excellent operation in 1965-69. The conceptual design study was issued for Molten-Salt Breeder Reactor (MSBR) as large as 1GWe plant. In Japan, small MSRs of 150MWe to 200MWe(FUJI-, FUJI-12 and FUJI-U3) have been proposed. FUJI-12 is a simple one-region core, and it attained a high conversion ratio of 0.92 by the batch chemical processing at every 7.5 years. However, FUJI-12 has to replace the graphite moderator at every 15 years, and this may cause additional maintenance work and cost. Then, an improved small MSR (FUJI-U3) has been proposed. The improvement is to introduce a 3-region core design concept in order to eliminate graphite replacement by reducing the maximum neutron flux. It is concluded that there is no need to replace graphite moderator for 30 years operation of FUJI-U3. In this paper, we investigated the other possibility of a two region core for the simplicity. Using one energy group neutron diffusion theory and assuming bare reactor, the optimum selection of region wise neutron multiplication factors can be theoretically and easily obtained. The validity of the selection was also proved by a numerical calculation. In MSRs, there is no burnup distribution of the fuel. The region wise neutron multiplications can be obtained by adjusting the volume fraction of fuel in a cell with a given composition of fuel salt. Thus, it is easy to apply the theoretical result directly in selecting the boundary of the region and the multiplication factor in each region and also to maintain the characteristics during the core burnup. The optimization of the actual core configuration was searched by a nuclear analysis code SRAC95 with the nuclear data library of JENDL3.2. In such case the region wise multiplication factor can be adjusted to compensate the neutron loss by leakage in order to attain criticality. Taking the theoretical result as the initial condition, the optimization was quite easy to accomplish. It is concluded that there is no need to replace graphite moderator for 33 years operation of a two-region core design concept.

Neutronic performance evaluation of Plutonium Recycling in two core sizes for a 250 MWt Molten salt reactor

Neutronic Analysis on Molten Salt Reactor (MSR) Using OpenMC Code With Variations of Geometry Core Fueled By LiF-BeF2-UF4

Flattening of Fast Neutron Flux Distribution in Molten Salt Reactor for Longer Graphite Moderator Lifetime

A Comparative Study of Th-U233 and Th-Pu Molten-Salt Reactor (MSR) with 2-region core

Neutronic Analysis of Modular Gas-cooled Fast Reactor for 5-25% of Plutonium Fuel using Parallelization MCNP6 Code

Natural Uranium Utilization in FUJI-U3 Molten Salt Reactor

Optimization of Core Regions and Fuel Fractions for Better Power Peaking Factor of 150, 450 and 1,000 MWth Molten Salt Reactor

A neutronic evaluation of a thorium-based molten salt breeder reactor

Extended development of a Monte Carlo code OpenMC for fuel cycle simulation of molten salt reactor

Design studies for A 50 MWth molten salt fast reactor

Core neutronic design of small modular molten salt reactor for submarine propulsion

Neutronic Evaluation of LWR Based SMR with TRU Fuel and Comparison with Different Core Configuration of UO2 and MOX Fuel

Transmutation of Transuranic Elements as Solid Coating in Molten Salt Reactor Fuel Channel

Core Optimization for Extending the Graphite Irradiation Lifespan in a Small Modular Thorium-Based Molten Salt Reactor

Neutronic and fuel cycle performance analysis of fluoride and chloride fuels in Molten Salt Fast Reactor (MSFR)

Self-sustaining Core Design for 200 MWe Molten-Salt Reactor with Thorium-Uranium Fuel :FUJI-U3-(0)

Preliminary Study on LiF4-ThF4-PuF4 Utilization as Fuel Salt of miniFUJI Molten Salt Reactor

On the Employment of a Chloride or Floride Salt Fuel System in Advanced Molten Salt Reactors, Part 2; Core Inventory, Fuel Burnup, and Salt Clean-Up System

Low enriched uranium and thorium fuel utilization under once‐through and offline reprocessing scenarios in small modular molten salt reactor

Investigating the possibility of using a mixture of thorium with different fissile materials as a fuel in TRISO particles for the PBMR-400 reactor

Neutronics Analysis for MSR Cell with Different Fuel Salt Channel Geometry