Abstract:Cu and unoxidized graphene composite films were prepared by electroplating under room temperature. Graphene was added to the electrolyte of Cu to form composite materials to improve the performance of Cu for interconnection. Composite electrolyte containing high concentration of graphene (up to 0.5 g/L) was prepared by adding CTAB as surfactant. And ultrasound was also used to increase dispersion degree and reduce graphene agglomeration in electrolyte. Average coefficient of thermal expansion (CTE) of the composite films determined by thermo-mechanical analysis (TMA) shows a decrease from 17.3 ppm/K to 14.2 ppm/K from 260 K to 320 K, which reduce CTE by 18 % compared with Cu. CTE of the composite materials can be reduced to 10 ppm/K at 243 K, which is only 60 % of CTE of Cu. The thermal conductivity of the composite materials measured by phase sensitive transient thermo-reflectance (PSTTR) technique shows an improvement from 385 W/m.K to 468 W/m.K. CTE and thermal conductivity of the composite materials both decrease with the increase of current density. And they also both increase with the increase of graphene concentration. The composite materials also show good mechanical properties. The average hardness is 2.5 GPa, which is about 2 times of Cu. And the average elastic modulus is 145 GPa, which is 38 % higher than that of Cu. The resistivity of the composite materials is basically equivalent to that of pure Cu. Result of the experiment proved that the composite materials have better performance under low temperature conditions. The improvement of material properties makes composite materials have good application prospects for 3D interconnection in the near future.

Interface optimization of graphene paper–Cu composite prepared by electrodeposition

Preparation and Characterization of Electroplated Cu/Graphene Composite

Effect of graphene addition on properties of Cu-based composites for electrical contacts

Surface Oxidation Engineering for Enhanced Interface Bonding Achieving Excellent Electronic Properties in Multilayer Nitrogen Doped Graphene/cu Composites Wires

Study on Nanoporous Graphene-Based Hybrid Architecture for Surface Bonding

Graphene/copper composite films: Interface regulation for enhanced electrical performance

Interfacial Design of Graphene Nanoplate Reinforced Copper Matrix Composites for High Mechanical Performance

Optimization of Cyanide-Free Composite Electrodeposition Based on π-π Interactions Preparation of Silver-Graphene Composite Coatings for Electrical Contact Materials

Vacant defect and nitrogen doping effects on the interface of graphene/Cu composites: Computational and experimental evaluation

Facile fabrication of layer-structured graphene/copper composite with enhanced electrical and mechanical properties

Graphene Interlayer for Enhanced Interface Thermal Conductance in Metal Matrix Composites: an Approach Beyond Surface Metallization and Matrix Alloying

Optimizing Electrodeposition Process for Preparing Copper-Graphene Composite Film

A novel approach for in-situ preparation of copper/graphene composite with high hardness and high electrical conductivity

Interface engineering and performance optimization of graphene-based nanocomposites

Fabrication of graphene/Cu composites with in-situ grown graphene from solid carbon source

Highly efficient enhancement of mechanical and tribological properties of Cu-based composites by addition of graphene-loaded Ni metal particles

Preparation of graphene nanoplatelets-copper composites by a modified semi-powder method and their mechanical properties

Enhanced interfacial bonding and mechanical properties of (TiC p +GNPs)/Cu composites by Ti-induced GNPs/Cu interfacial modification

Fabrication of Cu/Al/Cu Laminated Composites Reinforced with Graphene by Hot Pressing and Evaluation of Their Electrical Conductivity

Superior electrical conductivity-strength combination of an in-situ fabricated La 2 O 3 -doped copper/graphene composite conductor

A high strength and high electrical conductivity copper based composite enhanced by graphene and Al2O3 nanoparticles